Recent content by Dylan

  1. Dylan

    Wipers, blower, battery drain

    hey guys, I installed a turbo kit along with a wot box and guages recently and have come to find out my wipers wont work nor will they spray in any position on the switch, my climate control blower wont blow at any position on the switch and if I dont leave my car on a battery tender over night...
  2. Dylan

    on3 fuel hat wireing

    What im gona end up doing is run the gm regulator with a hobbs switch because i have them laying around and then over the winter Im gona start sourcing a full return system togather but try and find some deals on it so im not spending $600 to go return. I have plans of building motor in the...
  3. Dylan

    on3 fuel hat wireing

    If i go with the gm regulator and ran a hobbs switch would that be a decent way to go or still a bad route to take?
  4. Dylan

    on3 fuel hat wireing

    So i may just run a second fpdm. This would then do away with my relays correct. Would the new fpdm need to be wired into the pcm or how would that work. What all do i need hardware wise? I found a fpdm for 45 on ebay but uncirtin the harnesses and connectors i would need from there? Any info is...
  5. Dylan

    on3 fuel hat wireing

    Thanks for all the info. Im running a on3 kit with 70mm turbo using 2 320lph pumps with 60lb dekka injectors and running e85 trying to get close but stay under 500hp guess i didnt do enough research on my fuel system before hand. I have an idea but my tuner isnt likeing it so far but i dont see...
  6. Dylan

    on3 fuel hat wireing

    No im setup returnless :/ does this mean I either need to go returnless or find a new pump setup? I was assuming that there was a way to tap into the signal wire on the fpdm to control the fuel pumps
  7. Dylan

    on3 fuel hat wireing

    I have a 2 relay setup, power coming off the battery powering the pumps with a 40amp inline fuse. The relays have power ground and signal wires. I was hopeing i could run signal wire to the fpdm to control the dury cycle and run power to battery to make sure I dont blow the oem harness. Is this...
  8. Dylan

    on3 fuel hat wireing

    Hey guys, in the process of putting a turbo on my 06 mustang gt and am at the point of installing the fuel pumps. I went with the on3 triple billet fuel hat with 2 320 lph pumps. my issue is I dont know how to wire these up to the signal wire coming from the fpdm that tells the pumps how hard...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top