Recent content by ridindirty2130

  1. R

    Engine management light 2005 4.6 after cam phazer replacement.

    An alternator starting to go bad can do this. It has happened for me on my 08 several times after after I put in an under drive pulley. I went up to the 2010 model alternator (or go up in power) and the issues went away. It could also be that the phasers are still moving when they shouldn't. I...
  2. R

    Valve Train Noise...?

    I'm at 202K+ miles on my 2008 and I've found that ticking can come from multiple places. The most common that I've seen over the years of internet searching for my own car was from the fuel injectors/ignition coils, roller rockers, or somewhere within the drive train and/or the VCT system. Your...
  3. R

    Running Bad Around 3000 RPM's

    So a last ditch thought of mine was that hopefully cylinder 3 had a lot of gunk built up in it, which would allow some oil to get through and foul up the plug that I've replaced so many times. Since my last post, I added some Marvel's Mystery Oil to the oil and ran it for about 750 miles and...
  4. R

    Need Help Identifying Engine Part

    I found that it was the rod within the cmcv plates. It was leaking from the outside.
  5. R

    Running Bad Around 3000 RPM's

    Thanks. Glad to hear you're getting yours ironed out too. I wasn't able to do the compression test because I couldn't find any settings that fit (went to all of stores). I did check on my plugs again since I had them out and #3 had burnt oil on the electrode on up to about 3 threads. No...
  6. R

    Running Bad Around 3000 RPM's

    I'm running the stock tune still with no mods to effect A/F ratio. It literally only happens in 3rd or 4th gear when coasting at or gradually passing 3000rpm-3500rpm. I've had to change my shifting patterns just to get around all of this. That's the worst part about it is that The car runs great...
  7. R

    Running Bad Around 3000 RPM's

    Ended up just buying another stock intake (used). No luck. It did stop the air leak and the car is now running smoother but I'm still getting the misfires when holding in 3rd or 4th at 3000rpms.
  8. R

    Running Bad Around 3000 RPM's

    I have an air leak where the actuator connects to the cmcv (cylinder 8 side). I'll be taking my shot with the cmdp's hoping this is my issue but I'll definitely be following this thread as well.
  9. R

    Need Help Identifying Engine Part

    I need some help identifying a part on the engine block. It's located behind/beneath the bolt that holds down the intake manifold at the corner of cylinder 8 (pictured below). While searching for vacuum leaks, I came upon what sounded like an air leak coming from this part. I've listened to...
  10. R

    F.S- Roush 05-14 Billet Lower Control Arms and Whiteline LCA Brackets!!

    Are the relocation brackets going too?
  11. R

    Jabra Cruiser - Bluetooth thru Car Speakers Device

    What's the model number on this? How long have you had it?
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top