Miracle
"Shall not be infringed"
I picked up 2 5/16 inch spacers tonight, but I can get the wheel on, but it will not spin without BARELY rubbing on the caliper. So I have finally given up on finding a 10 MM Eibach Pro or MM spacer to run on my Mustang, and decided to go with just a "plate" type spacer and longer studs.
No site I have visited gives the dimensions of the wheel studs' splined shaft that holds it snug inside the hub.
Does anyone know the proper size to get? MM's website shows that you can get either a .57-.58 inch knurl, or a .603-.613 inch knurl.
Who knows?
And also... does anyone know where I could possibly find a hub centric type spacer with the following dimensions?
-Bolt Pattern: 5 x 114.3 metric, or a 5 x 4.5 SAE
-Hub bore opening: 70.5mm
-Thickness: 3/8" 10mm
No site I have visited gives the dimensions of the wheel studs' splined shaft that holds it snug inside the hub.
Does anyone know the proper size to get? MM's website shows that you can get either a .57-.58 inch knurl, or a .603-.613 inch knurl.
Who knows?
And also... does anyone know where I could possibly find a hub centric type spacer with the following dimensions?
-Bolt Pattern: 5 x 114.3 metric, or a 5 x 4.5 SAE
-Hub bore opening: 70.5mm
-Thickness: 3/8" 10mm
Last edited: