Synister500
Senior Member
Just as the title says I'm about to start modding my 2011 GT500. I purchased the car used with 8800 miles on it. It is bone stock with the exception of Magnaflow catback exhaust installed by the previous owner. I have had the car about 6 weeks now and it is an absolute blast to drive. But, I live in the heart of corvette country (the dang things are made right here) and stock just won't cut it. So before I even drove to TX to get the car I placed an order for some goodies to wake the new girl up. Everything is now here and I picked it all up from the local shop today. I figured a few mild bolt ons would be a good starting point.
Truck loaded up:
Everything unloaded:
The list:
1. JLT 127mm Carbon Fiber intake
2. Kooks 1 7/8" into 3" LTH with O/R X pipe
3. Borla catback exhaust (Stingers)
4. Metco 2.6 pulley
5. Metco HD idler pulley
6. Afco 10" dual fan HE
7. Colder range plugs
8. SCT tuner with Bob Kurgan start up tune
9. Bob Kurgan dyno tune
10. SOS triple gauge pillar pod
11. Autometer wideband, fuel pressure, and oil pressure gauges
Here is the car stock with the Magnaflows sitting in my garage:
I'm going to wait till at least Tuesday before she goes down to run at the track for some before and after results (as long as the weather cooperates). I hope to have everything installed in a week; then down to GA to see Bob and back here by NMCA Aug. 4th. If not then hopefully by Summernites cruise Aug 28th.
Hope to update with progress and pictures regularly.
Truck loaded up:
Everything unloaded:
The list:
1. JLT 127mm Carbon Fiber intake
2. Kooks 1 7/8" into 3" LTH with O/R X pipe
3. Borla catback exhaust (Stingers)
4. Metco 2.6 pulley
5. Metco HD idler pulley
6. Afco 10" dual fan HE
7. Colder range plugs
8. SCT tuner with Bob Kurgan start up tune
9. Bob Kurgan dyno tune
10. SOS triple gauge pillar pod
11. Autometer wideband, fuel pressure, and oil pressure gauges
Here is the car stock with the Magnaflows sitting in my garage:
I'm going to wait till at least Tuesday before she goes down to run at the track for some before and after results (as long as the weather cooperates). I hope to have everything installed in a week; then down to GA to see Bob and back here by NMCA Aug. 4th. If not then hopefully by Summernites cruise Aug 28th.
Hope to update with progress and pictures regularly.
Last edited: