05stroker
Never enough power guy!
All prices shipped lower US48.
Paypal is [email protected]
Custom N2O kit by HSW. It has all black and silver fittings instead of the red and blue ones. It is a Deep Impact kit that has a polished mirror finish bottle and Zex bottle opener. This kit also includes a purge kit, N2O filter, blow down tube with pressure reg., jets from 35-200 rwhp, heated bottle bracket, and custom console switch plate along with a Microedge controller. Closer pics available upon request. This kit has been on my car but never sprayed. It is a one of a kind setup I built for my car and includes most of the wiring. It will need wires from the console to the solenoids. I have all the original instructions and manuals. I have over $1600 in this setup. SOLD
Fuelab Regulator SOLD
Autometer Boost gauge
$35.00
Semen Deka 80lb injectors SOLD
FRPP 4:10 gears, used about 500 miles. SOLD
Edit: I need to make sure you are aware of a chipped tooth on the pinion. It is not in the contact path and does not effect performance. I just want you to see it first. I did it removing the pinion bearing to reshim. Pic is below.
Innovators West 8 rib crank pulley for Procharger
$85.00
Fuel rail adapter SOLD
New faux cap
$20.00
MSD boost a pumps
$200.00 ea or $350.00 for both
Stock MAFs 1 new and 1 used
New $40.00 Used $30.00
Moly coated Rod bearings 4.6 (non s197) fits 96-04 4.6 281
$40.00
Painless batt. solenoid
$40.00
Trans temp sensor full sweep.
$15.00
Diablo programmer 07 must Vortec S/C
$75.00
Paypal is [email protected]
Custom N2O kit by HSW. It has all black and silver fittings instead of the red and blue ones. It is a Deep Impact kit that has a polished mirror finish bottle and Zex bottle opener. This kit also includes a purge kit, N2O filter, blow down tube with pressure reg., jets from 35-200 rwhp, heated bottle bracket, and custom console switch plate along with a Microedge controller. Closer pics available upon request. This kit has been on my car but never sprayed. It is a one of a kind setup I built for my car and includes most of the wiring. It will need wires from the console to the solenoids. I have all the original instructions and manuals. I have over $1600 in this setup. SOLD
Fuelab Regulator SOLD
Autometer Boost gauge
$35.00
Semen Deka 80lb injectors SOLD
FRPP 4:10 gears, used about 500 miles. SOLD
Edit: I need to make sure you are aware of a chipped tooth on the pinion. It is not in the contact path and does not effect performance. I just want you to see it first. I did it removing the pinion bearing to reshim. Pic is below.
Innovators West 8 rib crank pulley for Procharger
$85.00
Fuel rail adapter SOLD
New faux cap
$20.00
MSD boost a pumps
$200.00 ea or $350.00 for both
Stock MAFs 1 new and 1 used
New $40.00 Used $30.00
Moly coated Rod bearings 4.6 (non s197) fits 96-04 4.6 281
$40.00
Painless batt. solenoid
$40.00
Trans temp sensor full sweep.
$15.00
Diablo programmer 07 must Vortec S/C
$75.00
Last edited:
