RollingThunder
Member
A while back, I neglectfully hit a curb with the driver's side rear wheel. The wheel began wobbling slightly, causing the rotor to spin against the pads at an angle, causing a squeaking noise. I deducted that the axle shaft was bent.
I bought stock axles from a member on here and just finished replacing my axle with his this morning. Upon putting the rotor and caliper bracket back on, I see that the axle sticks out further than the original one, causing the rotor to come into contact with the bracket.
What gives? Were there differences in axle lengths throughout 05-09 production?
Sent from my iPhone using Tapatalk
I bought stock axles from a member on here and just finished replacing my axle with his this morning. Upon putting the rotor and caliper bracket back on, I see that the axle sticks out further than the original one, causing the rotor to come into contact with the bracket.
What gives? Were there differences in axle lengths throughout 05-09 production?
Sent from my iPhone using Tapatalk