Recent content by 1JOE

Thank you!! Great example!! I will get it swap out this week.. Thanks again!

Good afyernoon everyone I have a 2011 Mustang GT the AC has been cold as it should be It started getting warm the other day.. It will go from cold to warm.. I was able to look at it today and my high side is at 400? Can this be my Expansion valve going bad? BTW my low side is 40-50 it was about...

Great thread guys!! I have a 2011 Mustang GT 6 Speed manual and i want ho do the swap I have the cluster I'm ordering the switch Does any one know how i need to do the wiring for the switch? And build codes for mine? I also have the bimbo brakes on mine but I don't know if my abs has been...

Good afternoon I dont think there are any differences in the injectors But in 2009 ford did change the Charge motion Plates.. They are built into the intake.. They used to be removable.. I hope this helps..

Hey guys I know it dosn't make since.. The v6 was shot the owner ran it hot so my son bought a wrecked 2010 gt.. I told him he could have the 2014 I didn't know that it was this much to the build.. The 4.6 only has 45k on the engine We already switched everything over. Like i was saying before...

I'm working on a 2014 V6 that my son and I swaped a 2010 gt engine and trans ect.. I'm using my 2010 pcm so the engine and trans wiring stayed on the engine and trans when we swaped them So the pcm connector that stays on the car i have to swap out that connector.. So my question is how should...

Can anyone help me out with a pinout for the 2010 Mustang GT PCM connector? Thanks!

Thank you Sir!! Sir is there a way that i can find out the pin out for the wiring harness that stays on the car and that plugs into the pcm? Its the middle plug for the pcm? Thank you..

I have a 2014 V6 my son bought the 2010 at an auction it was wrecked cannot be fixed so I let him have the 14 he sold the V6 engine and tranny and we switched everything over from the GT over to the 2014. The 2010 as I said before it was wrecked and the PCM was broken during the wreck. we bought...

@86GT351 would you mind me messaging you as well for the info about the same connectors for a 2010 Mustang GT? Thank you!!

Good afternoon my son has a 2010 Mustang GT That he installed a new motor in when they took out the old one they did not do a great job with labeling things and keeping up with things go and where things hook and so on!! I have it all back together but now I need a little help with the wiring...

I have a 2010 Mustang GT and I’m looking for a wiring guide my son put in a new engine but didn’t take not of where things go. I have the engine and tranny put back together and in the car but I can’t figure out this wiring so if anyone could help me with this this would be great thank you??