Recent content by BumblebeeGT

Hey lito, I'm looking for someone to tune my 3v mustang and I heard your the man. I am about to start installing an on3 turbo kit. Are you able to remote tune for that, and what tuner do you support if so?

I replaced the clutch master cylinder and got the mcleod braided steel clutch line while I was doing that. That still didn't help though. I guess the only thing I have left is to drop the tranny and look at the clutch again.:headbashing:

It did sit for a while before I was finally able to swap the motor in, but wouldn't I have been able to see signs that it had debris in the fluid when I was vacuuming it out and moving the fluids around? Also, I have tried to inspect the master cylinder, but it has no visible leaks. Is there a...

My clutch set up is all exedy. Everything looked fine to me besides my pressure plate being rusty, so I went ahead and put a spare new exedy pressure plate on that I had laying around. I did notice that when we were installing the tranny back on when the throwout bearing made contact with the...

I don't think anything is faulty with the transmission it was working fine before my original motor blew. But I guess that is a possibility. I'm kind of stumped at this point.

Well even with the new throwout bearing in I can't get it to go into gear while the engine is running. I've tried using the mightyvac to get the air out of the lines but that doesn't seem to be working. Any other ideas?

well, I finally found the time to drop the transmission today and it looks like the throwout bearing was definitely due to be replaced. I would think this would be my cause for not being able to go into gear while it was running. what do you guys think?

clutch is aftermarket and the slave cylinder is stock. there isn't much mileage on the clutch because my old engine went out not long after I put the clutch in, but the slave has roughly 145k miles on it.

I recently dropped a new 4.6l 3v engine into my 2006 mustang with a manual transmission and it starts up fine, but when I try to put it in gear it wont let me enter any gears while its running(I can go into any gear while the car is turned off). when I try to start it in first with the clutch...

Hey guys, so the motor in my s197 recently threw a cam phaser code so i took it to the shop, and they said a few of the cylinders were filled with oil and some of the spark plugs got broken off into the block (im guessing the piston slapped them) and now it needs a whole new motor. So im really...