Recent content by Christenn23

  1. Christenn23

    Supercharger belt slipping

    middle of the pic. There is a clean spot where I wiped it with my finger. The supercharger has less than 1,000 miles, is this excessive amounts of dust?
  2. Christenn23

    Comparison with new ecoboost

    What is the name of his channel or website?
  3. Christenn23

    Blower surge

    Yes it has a bypass valve. Slipping the clutch a little and easing into the throttle helps it some. I guess I just need to change the way I drive a manual, probably picked up a lot of bad habits over the years.
  4. Christenn23

    What have you done to your mustang today?

    I'm envious. My heat exchanger is awful, once the blower gets heat soaked it feels like I'm N/A.
  5. Christenn23

    SCT X4 or nGauge

    Sct is more widely supported, almost every tuner shop around me uses them. I have an sct x4, I like it because you can configure it to show a lot of readings on a single page, but it's big and clunky and doesn't flow well with the look of the interior, my brother uses an ngauge(Lund) on his...
  6. Christenn23

    What have you done to your mustang today?

    I gapped a 96 V6 Mustang in my supercharged 2011 5.0. I'm headed for the Big time.
  7. Christenn23

    Blower surge

    I'm a complete newb to superchargers so thanks for the info, sounds like a custom tune should clean it up.
  8. Christenn23

    Blower surge

    I have the Edelbrock E Force stage 1 kit on my 2011. Runs great at wot, but driving in 1st & 2nd gear under normal driving conditions as I slowly press on the gas pedal it will surge, kinda like if you were to goose the throttle real fast then let off. From what I've gathered it seems that tune...
  9. Christenn23

    Boss 302...over the cliff !

    This does not constitute a crowd killer!
  10. Christenn23

    PD supercharger on higher mileage 5.0

    When you say "run hot" do you mean I was talking about the actual front cover of the engine block. I have the gen1 cover which has to be taken off and replaced with a gen2 cover. That would've required removing the heads and crank pulley, just didn't want to tackle it because I have zero...
  11. Christenn23

    PD supercharger on higher mileage 5.0

    I was actually leaning towards a DoB kit, but removing and replacing the front engine cover turned me away. So I just went with the Edelbrock, with the intent of just upgrading the heat exchanger. Interesting, thanks for the info. When you say "run hot" do you mean under wide open throttle or...
  12. Christenn23

    PD supercharger on higher mileage 5.0

    I have 2011 5.0 with 70,000 miles that I'm going to be putting an Edelbrock PD supercharger on. Any experiences with higher mileage Coyotes getting boost, things to lookout for? Pros/cons, if any.
  13. Christenn23

    How has your experience been with that Edelbrock sc? Just bought one for my 2011 GT.

    How has your experience been with that Edelbrock sc? Just bought one for my 2011 GT.
  14. Christenn23

    Built 13 gt or stock gt500

    Go for the GT500. Its always going to be more reliable purchasing the boosted car that has millions of dollars worth of research and development and was designed from the factory to be boosted.
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top