Recent content by Conway Hunt

  1. C

    LED headlight bulbs?

    Mailman - Pentalab's frustration is echoed by many on the forum. I too have experimented with LEDs but have been frustrated by final fit tolerance of bulb-to-receptacle alignment. If the LED blades do not align perfectly vertical, the result is unsatisfactory. After many expensive trial &...
  2. C

    5R3Z-7213-BAA Shifter Knob

    I posted this on the IMBOC forum roughly 1.5 years ago. I would consider letting go some or all of these pictured above: When my "Chalmers" (DHG5430) was new, I suspected that limited production would mean original replacement parts would become scarce earlier rather than later, so I purchased...
  3. C

    Removing the "Knee Bolster"

    In the process of replacing the windshield wiper multi-function stalk on my 2008 GT, after detaching the battery Neg. terminal clamp the next step is unscrewing the 2 x 7mm screws fastening the lower instrument panel "Knee Bolster". This is required to access the steering column upper and...
  4. C

    axle back

    Installed new FRPP M-5230-S on my 2008 BULLITT (Chalmers) in July. Upon comparing driver’s side OEM to what came in the box revealed that final assembly techs in Flat Rock, MI needed to apply a 45 degree bend to the aft upper hanger rod essentially pointing it toward the tail light. In order to...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top