Midlife Crises's latest activity
-
Midlife Crises replied to the thread Car Jerks Hard Before it Hits Boost/Power.Is there a bypass valve transferring at that time? -
Midlife Crises replied to the thread This ground wire.Yes. That ground wire connects to the rear of the drivers side cylinder head.
-
Midlife Crises replied to the thread Axle Girdle Panhard Bar.You can see the BMR relocation bracket on the bottom right corner of the table. Next to the orange hammer.
-
Midlife Crises replied to the thread Axle Girdle Panhard Bar.If you are referring to this one; yes you will have to relocate the panhard bar.
-
-
Midlife Crises reacted to Dino Dino Bambino's post in the thread Caster and Camber Alignment ECCENTRIC Bolt Kit with
Like.
The two longer eccentric bolts go on the lower end of the front struts where they are mounted to the spindles for adjustment of the... -
Midlife Crises replied to the thread Caster and Camber Alignment ECCENTRIC Bolt Kit.I think they can be used on the lower control arm if you complete the slotted mounting holes.
-
Midlife Crises replied to the thread 2010 4.6 overheating.Those darn “O”Rings.
-
Midlife Crises reacted to GriffX's post in the thread Designed to be this way or? 2005 GT with Like.
I have the Tokico shocks and can change the compression/rebound rate. My car starts to jump around on bad roads when the damping rate is...
-
Midlife Crises replied to the thread Designed to be this way or? 2005 GT.Front wheels pointed towards center is positive toe and is most common for hiway vehicles. Offers stability at speed. Negative...
-
Midlife Crises replied to the thread Designed to be this way or? 2005 GT.Your alignment numbers look very good to me for a stock suspension. The chassis appears straight, not warped or twisted. In factory form...
-
Midlife Crises replied to the thread Timing Problems.You have 200,000 miles on the clock so a timing set replacement is a very good idea. Remove the front cover and replace the crank gear...
-
Yeah, well venturi refers to the principle involved in using flow to increase or decrease pressure through velocity where technically a...
-
Double check your crossover tube. I had this issue once and the tube looked like it was attached but was not seated all the way. I...
-
Midlife Crises replied to the thread STEEDA HEAVY DUTY CAMBER /CASTER PLATES TROUBLES.When installed, there isn’t much to see.
-
-
Midlife Crises replied to the thread STEEDA HEAVY DUTY CAMBER /CASTER PLATES TROUBLES.If you look at the nipple on the center section you can see two “O” Rings. These had failed and allowed the spring perch to wobble...
-
Support us!
Support Us - Become A Supporting Member Today!
Click Here For Details
Sponsor Links
