Recent content by obxdude018

  1. O

    DOB Gen1 Manifold GT450

    Up for sale is my Gen1 Manifold, all hardware will be included with this, few bolts have some rust on them, will include 3/4 fragola ends as well as GT500 fuel rails(these are painted red, but paint should be easy to strip off). In the process of polishing it back up. Some minor surface...
  2. O

    WTB 3V fuel rail

    Like title says need fuel rail from 05-10 3v.
  3. O

    Cooling fan wiring bypass problems

    So I did a wire tuck and relocated the BEC and PCM under the dash. I had problems before with the fan burning up the BEC and decided to create my standalone circuit. I kept the trigger for the low(DB) and high(LG/VT) speed. However, after the engine hits the set temperature for the fan speeds...
  4. O

    Cooling Fan problems?

    So have searched past threads, not a lot of definitive solutions, but plenty of people with problems. However, both low speed and high speed have burned up the BEC connector. Is it better to replace the connector and fan and keep an eye on it. Bypass Low and High from the BEC or go with a...
  5. O

    Wire Tuck Thread

    So is this the point everyone used in the firewall for the wires and from there were the wires run into the engine bay through the opening along the firewall? I'm mounting both PCM and BEC under the dash.
  6. O

    Wire Tuck Thread

    I have a 0 gauge wire from battery to block and either 4 or 2 gauge for the fuse box, sounds like you are placing everything in the same place that I will be. Will you be running all the wires back out through the passenger firewall opening?
  7. O

    Wire Tuck Thread

    In the process of doing a tuck on my '05, plus painting engine bay and upgrading to 8 rib belt for D.O.B. I have a power block in the engine bay since the battery is in the trunk. You could relocate the battery and go that route or replace the cable with a longer one, to be honest I don't...
  8. O

    Car off Amperage Draw

    Well it does have a Shaker system, didn't know that and they are disconnected now, so that has partially fixed some of the amp draw, but as soon as that starts to get fixed, the car decides to throw a litany of dtc's and activating limp mode. So now i have to figure out why it's throwing...
  9. O

    Car off Amperage Draw

    To be honest, I couldn't tell you if it had a Shaker in it or not, the guy I bought the car from originally had swapped all the electronics out for a trunk mounted Rockford Fosgate system. I pulled the equipment out after the cap went bad.
  10. O

    Car off Amperage Draw

    Have an amperage leak on my car that I have begun to identify, it's currently sitting at 1.3 amps with the car off, nothing on. I have no radio or a/c in this car. I found fuse 16 in BEC is drawing about 1 amp of that. I just need to know how much current draw i should be seeing when the car...
  11. O

    Radio Delete 05-09

    Does anyone know of where to find a delete panel, Rehegan is the only thing on this forum that I could find who had made them. There are gauge panels out there, but I just need a full blank cover to hide that opening. Anyone who knows of a company that sells them or someone who could fabricate...
  12. O

    Cooling system issues

    So today, had some issues with it boiling over again. I noticed that the low speed fan is not coming on, which does not help my situation out. So for now I turned the high speed fan down to turn on at 192. Drove the car for ~60 miles, did not have a boiling problem at all. The temp would...
  13. O

    Cooling system issues

    I couldn't find an exact answer based upon previous threads. Had an issue pop up while going to a Spartan Race. So my car seems to be boiling coolant out. I got to my destination on Saturday and steam just came rolling out from under the hood. I ran my race, put some water in the car and...
  14. O

    3v block...heads..cobra crank

    Price for Heads and Block shipped to 27529
  15. O

    fs: stock 3v shortblock $500

    Is this a complete shortblock? I am looking for a bare block for a build
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top