Corbeau Harness Install

[remainvayne]

Do it (half) right with a removable harness bar.

I know I know. But I already have the bolt-in harnesses and don't particularly like the looks of a harness bar.

 

[remainvayne]

Took a blowtorch to them and got the passenger right bolt out and the left bolt started... and then the head stripped. So I'm fucked. Guess I'll mount one strap in the right bolt hole I circled on the passenger side and the left harness where the rear passenger side seatbelt bolts down.

Might look silly, but it looks like the easiest course of action.

 

[MVSicari]

I used an allen key that "kinda" fit, mine came out fine... Good luck.

 

[Solar_Eclipse2]

Took a blowtorch to them and got the passenger right bolt out and the left bolt started... and then the head stripped. So I'm fucked. Guess I'll mount one strap in the right bolt hole I circled on the passenger side and the left harness where the rear passenger side seatbelt bolts down.

Might look silly, but it looks like the easiest course of action.

Vise grips. Tighten them down on the head and turn the bolt. Then order another bolt from Ford.

 

[remainvayne]

This thread is 4 months old. I got my harnesses in, but tightening them to the correct length was easily the biggest pain about the whole process.

FYI: anyone who doesn't believe the countless members on this forum about the MMR rear seat delete being a pile of $hit is too naive or hard-headed.

It is, in fact, a pile of $hit and looks the part too. I wish I would have listened to everyone about not skimping on it and ordering the piece from rearseatdelete.com. After spending that much money on the seats, tracks, and harnesses I should have dropped the extra $100 and got a decent rear section.