Installing 8 rib kit, need pulley torque specs

[Pumpkinfish]

I finally made it over from the dark side...lol!

Any way I bought an 8 rib setup from GI Joe for my Saleen. I have searched but can't find a list of the torque specs for all the pullies. Can anyone help me out?

I can't wait to get this on and give it a good romp this weekend

 

[cekim]

I finally made it over from the dark side...lol!

Any way I bought an 8 rib setup from GI Joe for my Saleen. I have searched but can't find a list of the torque specs for all the pullies. Can anyone help me out?

I can't wait to get this on and give it a good romp this weekend

Does this do the trick?

 

[don_w]

It's about damn time you got here!! Welcome! Roper is buying the beer... it's his birthday!

 

[ZmanM3]

Welcome to the site!

 

[Pumpkinfish]

cekim, that is perfect. Do you have the specs for the crank? That was not listed.

Don, make that a Pabst Blue Ribbon...lol! Do they still sell that piss water?

 

[pcdrj]

I can't wait to get this on and give it a good romp this weekend

John,

Pocono again?

I'm also going to do the 8 rib soon. JDM just dynoed a car with a 2.9 pulley then installed the 8 rib with a 3.0 pulley. It made the same power. Jim thinks it's due to pulley slip. I can see that since I hear mine squeal alot and I'm sure it's slipping even when I can't hear it.

 

[Pumpkinfish]

Paul,

I have been debating if I want to do Aug or Sept. It will most likely be Sept since I want to get stiffer bushings and new ball joints for my front. Otherwise I am ready! Occasionally I will hear mine slip when I am hard on and off the gas. Not enough to seriously take away boost but enough that I know it happens if that makes sense.

 

[cekim]

cekim, that is perfect. Do you have the specs for the crank? That was not listed.

That's a "procedure" rather than a spec - its in here (engine assembly PDF) on page 23