Momo Steering Wheel & Hub in ‘08

[Bedouin]

Anyone install a Momo hub & Steering Wheel (or NRG, Sparco, etc) in an ‘05-‘09 and retain the (Momo) horn, & keep the airbag light off?

I can do without cruise control & self canceling signals in my ‘08, but I’ve searched for hours & seen nothing definitive about what airbag resistors plug in where, or horn wires, & do I keep the clockspring in place or not.

I ordered this Momo (non quick release) hub & wiring from AM, but there’s zero wiring specifics about where that airbag resistor/wire or the two horn(?) wires would plug into.

A customer wrote this install review in AM, but gave no wiring details.

How to Install MOMO USA Steering Wheel Hub (05-14 All) on your Ford Mustang | AmericanMuscle

www.americanmuscle.com

 

[XJCasper]

I found a video on YouTube for an NRG. That explained the wiring situation. I have had to pull mine apaetaciuple times to redo the horn wire. It's currently not working again. Ot currently in a situation I can grab pics. Look around YT a little.

 

[Bedouin]

Thanks XJCasper, I’ve searched YT pretty hard…only vid I found that was close is TruckandRoll guy with a Momo wheel on an NRG q/r hub, but he didn’t connect the horn. He removed the clockspring & plugged two resistors into the 8-9 & 1-2 slots in the column plug that goes into the clockspring. He said the blue wire in that column plug was for the horn.

I’d like to keep my clockspring in place, & the rear cavity of the Momo hub pictured above should have enough room for clocksping wires.