OBX Headers

[05bluestang]

Anybody running these? Problems? OBX been around for a while.......
http://cgi.ebay.com/ebaymotors/OBX-...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

And yea I know Kooks FTW.............

 

[Matt D]

Ive seen the obx in person and they actually look really good. Welds are spot on and everything. The collectors are really close to the chassis that is the only down side. They are very decent price if you don't want to drop for Kooks or American Racing headers.

Can't say about power gain or how long they last, I didn't really answer your question >.< lol

 

[05bluestang]

Ive seen the obx in person and they actually look really good. Welds are spot on and everything. The collectors are really close to the chassis that is the only down side. They are very decent price if you don't want to drop for Kooks or American Racing headers.

Can't say about power gain or how long they last, I didn't really answer your question >.< lol

I really want some long tubes but can't drop the coins for Kooks right now. Maybe I should wait

 

[eng943]

I have them, and so far so good.

 

[05bluestang]

I have them, and so far so good.

Any fitment issues?

 

[eng943]

Any fitment issues?

They were a bit tight on the driver's side, but with a little encouragement they fit fine.

 

[Konablue10Gt]

I have them on my car. Quality is very nice!. Here is what I did to make them fit.

I dimpled one of the driver side primaries for the steering shaft. I still have stock motor mounts

Clearanced bellhousing a bit on the driver side. Just used a carbite bit took less then five minutes to do

Reuse your factory studs, and gaskets. Just trim about a 1/4 inch of of the top studs on #7 & 8 primary tubes

And I actually used a small linked chain to bring the collectors away from the frame rail.

It sounds like a lot but really isnt.

Without a tune they picked me up 2 tenths and almost 3 mph.

I am running them without cats

 

[05bluestang]

Thanks guys