PCV blockoff plates for CJ intakes??

[DTL]

I searched around a bit, but haven't come up with an answer or solution to this. Does anyone make a block off plate for the PCV port on the intake manifold like the one pictured below? Right now, I've just got a cap over it with a zip tie, but it looks like poo.

Sorry for the poor pics, but the sun was going down behind the open shop door.

 

[Bullitt 3309]

No plates I know of, I had a cap as well. I have since went back to a closed system using the new UPR separators.

 

[Mustang Mark]

I would just make one out of some thin sheet metal and seal it up with some RTV.

 

[DTL]

Problem is, it doesn't seal at the outer flange. It uses the inner o-ring. You could *probably* get it to seal up, if you used a decently thick piece of aluminum and some RTV. I wish I knew where to get a spare fitting. I've got a buddy with a CNC shop, who could probably make a plug. I just don't want my car torn apart, waiting on him.