wdrlaw
Junior Member
I have the Steeda s/s brake line kit. Rear wheels installed effortlessly. Replacement bracket was an exact match for the OEM part. Front wheels, eh. Stock bracket was brazed to the AN female fitting. Heavy steel, left and right mirror image. The brackets Steeda sent are drilled for the 10mm bolt and with an index tab, just like the stock ones. Instead of angled/twisted steel with a 5/8"/16mm hole, they are simple "L" braces with a hole threaded for an allen bolt and a pinch clamp. The clamp is sized for the brake hard line. When installed, it's an inch or two short of the hard line. Since the Steeda brackets are identical and have index tabs, I can't have installed them backwards, upside down, or swapped left side to right. I cut the bracket from the OEM line, but haven't drilled it for the AN fitting yet. Attached are two pix: one of the Steeda bracket and clamp, one of the stock bracket cut from the OEM line. Can't figure out how the Steeda brackets work (if they do), and for the first time ever, Steeda has not been helpful. Please tell me if I need to fabricate my own brackets, or I am too freaking stupid to figure out how the Steeda brackets install. Thanks!