Search results for query: *

That's what the plan was most likely going to be, but seeing as I have a general engineering degree and a decent amount of handiwork skills, it would be neat to at least try and figure out and if it's something simple fix it myself. Also I know there's such thing as fluids that fix leaks, but...

I know very little about the radiator system in cars, but it would appear my car is leaking coolant. I noticed my heater wasn't heating my car so I checked the reservoir and the fluid level was at the bottom. I topped the car off, but the the engine wasn't 100% cool, however it had probably been...

Any advice to get the moisture barrier off to get the broken glass out? I'm struggling a bit with it.

I actually got a little lucky. I drove past a scrap yard and decided to see if they had anything, they had a window in good condition that matched my tint (except I think it's film instead of ceramic) for $80.

I may have to do that. It just occurred to me that one of my friends manages a Ford dealership

I was in DC over the weekend (parked on a well lit highly visible road) and some goober broke into my driver side window to steal an old backpack full of clothes I was going to donate. I'm normally wary of buying off Amazon, but they are the only windows I see for sale online. Are they a good...

Howdy folks. I finally installed the new subs in my doors. The only issue being that I had to cut the enclosure to make them fit. What must I do to reseal the enclosure. Also, will issues will I run into if I don't? I have a high and low pass filter going into to the sub if that makes a difference

I have found one. One question though, is the power rem wire on the new amp the same as the mute wire on the old one?

Stock amp wiring diagram

Kicker Key 500.1 diagram

How do the stock door subs amp work? There are 4 output wires per amp that are the hot and ground for each subs coil, but how do the 6 output wires work? If I had to guess 4 of then correspond to the 4 inputs and the other 2 are the power and ground to the amp. But then this leaves the question...

Also, whats the ideal location for the fuse box?

Cool, thanks. 8 Guage is still good for post-distribution block? What's the general rule of thumb for wire sizing?

Howdy fellas, I have a kicker 200.4 that requires a 20A fuse amd a 500.1 that requires a 60A fuse. My plan is to run a 4 guage wire to a fuse, then run that to a distributor that splits into two 8 guage wires. What fuse size would I need? Also, an alternative is run the distributor first, then...

Howdy fellas, I just did a swap from a 4 to 6 guage cluster on my 07 v6, and was wondering if it would possible to drill through the outer "buttons" on the placeholder button cluster, screw into the holes, and yank it out. In short, is there anything holding the buttons in place other than...

Also I got the leather armrest cover I'll have them do

Howdy fellas, I bought American Muscles Alterum leather door inserts set as well as a chrome trim ring and now that I've got the job figured out it looks to be outside my skill level. Given I already have the door panel off and have the materials on hand, how much do you think I could expect...

Spice up the interior, that's where you spend most of your time anyway

It's a rear view mirror with microprocessor. These are the two I'm looking at https://www.bestbuy.com/site/vantop-hf612l-12-4kuhdfront-and-rear-mirror-dash-camwith-built-in-gps-and-voice-control/6454671.p?skuId=6454671 and...

Howdy, I'm looking at getting a smart mirror put in my car; ideally one that simply turns on when I'm in reverse and has a compass and thermometer overlay at any other times. Is there something on the market for me? The only one's I can find are either too complicated or don't fit my constraints.

Howdy. I recently upgraded from the 4 cluster dash to a 6 cluster dash and that got me thinking I should probably come up with a to-do list for interior upgrades that I could do as a break between hardcore technical stuff, so I was thinking I could get some advice from some of you that have...

Does anyone know the guage wire comes stock? I ran a quick spice simulation to simulate the effects of various wire guages on an audio file, and there's not too much of a difference in sound except the extreme ends, I should be fine though, as the sound change only started being noticeable...

The system only ends up being 50w × 4 for the main speakers and 150w × 2 for the subs. My ee experience says that the wires shouldn't matter as the only issue they'd pose is a fire hazard if there was too much power going through it, but I don't think I'm pushing that much power. Do you have...

I guess the question I'm trying to ask is how much of this stuff do I really need versus what can I reuse from the OEM system. Looking at the list the guy from Crutchfield gave me, I clearly don't need several of the things on it. For example, the car comes with two amps so I figure I can reuse...

Howdy folks, I bought a set of Kicker Key 200.4 and 500.1 amplifiers and a set of Pioneer TSA2000LD2 subwoofers. What parts do I need to install? I'm assuming a heat gun to remold the plastic around the wider base subwoofers, some sorts of fuses (how do I figure out the specific size?)...