clutch

  1. gtnoop

    McLeod rst vibrations

    So I just installed this McLeod rst twin disk clutch in my 2013 gt/cs mt82 car with a McLeod aluminum flywheel, oem ford throwout bearing, and a high load roller pilot bearing in October of 2023. The car also has a dynotech one piece aluminum drive shaft. The previous clutch was an exedy single...
  2. Drunkenturtles

    Whole Drivetrain upgrade

    (14 GT mt82) Finally preparing for a Paxton centrifugal, going for 600-650whp. I'm going to do most of the work myself, starting with clutch and driveshaft. Already upgraded brakes, got an MGW shifter, and diff sorted out with new LSD and 3.75 gears. For my power goals, what clutch kit works...
  3. ThatOneS197UKnow

    Bent Clutch Pedal + clutch/brake issues ‘12 GT

    I just recently purchased a 2012 Ford Mustang GT Premium, it has come with a multitude of issues. One of which being the clutch pedal being crooked to the left, which I believe could be causing the issues i will now state. Whenever I shift at high RPM’s, the clutch pedal will stick to the...
  4. Andrey Sidorov

    McLeod clutch issue

    Hey everyone, does anyone of you guys run the mcleod super street pro clutch kit number 75201 with their Lightened Steel Flywheel? Im about to pull the hair out. I just had and engine swap to another 4.6 3v and decided to change the clutch as well with this combo. Shop installed everything and...
  5. Adomis63

    Interesting Noise at Idle

    Hey folks, I'm hoping you all might be able to help me pinpoint the source of a noise my '07 gt is making at idle. The noise it makes is sort of a light knocking/tapping sound. -It doesn't happen right away from a cold start - it takes a minute or two before it becomes audible. -On warm...
  6. Mark_K

    Brake bleeding questions

    I have a couple questions about bleeding my brakes. I replaced all the flexible lines for my brakes with braided stainless steel lines. I put in new rotors all the way around and new pads. I also installed speed bleeders, and have a manual transmission, which I understand uses the same fluid...
  7. Awad Alibrahim

    Best affordable clutch?

    My 2009 Mustang GT has about 75k miles, and recently I've felt that the stock clutch doesn't preform as well as it used to. I daily drive the stang and was looking for the best affordable clutches that handle at least 500hp and keep the stock pedal feel or provide an even lighter pedal feel.
  8. Oliver Vigil

    Top Bell Housing Bolt

    Been trying to get the top driver side bell housing bolt for a clutch change. I have read everything I have found and spent literally 10 hours trying to get the bolt off. Sprayed with PB, bought new extension set to reach cover more than 25", used breaker bar, impact gun, everything I could...
  9. K

    SPEC stage 2+ clutch issues

    Hello, I had a shop install my SPEC stage 2+ clutch in my 2011 track pack, drove it just over 500 miles before driving it hard, but after hard shifts the clutch pedal feels slightly “crunchy” upon release, but it’s fine when pushing the pedal in, I also noticed sometimes it will have a hard time...
  10. R

    2011 Mustang 5.0! HELP! Growling noise coming from clutch?

    Hey guys sorry if im repeating a thread but i have not found help on this anywhere! Ive had other mustangs that ive had issues w/ a throwout bearing or similar but I need help with this particular situation! I have a 2011 Mustang GT with an MT-82 at 108K miles. I did the tranny oil change at...
  11. Mad Elliott

    Clacking noise when taking off or driving slow at low rpms(manual)

    Hey, I've been having a clacking noise on my 06 Mustang GT w/ manual trans. The best way I can describe noise is a metal sounding repetitive clacking that only happens when driving slow at lower RPMs (1500-2000 or so) and when taking off slowly. Sounds like it's coming from underneath the car...
  12. W

    Clutch issue

    whenever i release the clutch in my 2008 gt, half way through to fully released i start to feel a chatter of stutter, then shifting into second gear there is a big clunking sound. Any thoughts what it could be?
  13. beefcake

    Team Beefcake - 20% Off Mcleod Today Only

    Now is the time to get the RST or RXT McLeod Clutches you need for your 11-17 Mustang with MT82 trans. http://www.teambeefcakeracing.com/mcleod.html + Sale includes Clutches, Flywheels and Accessories + 20% Off ** No Coupon Needed + Great for high power forced induction

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top