I’m currently replacing the 5r55s transmission in my 2007 V6 and I didn’t have any issues getting the old one out but when I jack the new transmission into place I can’t seem to get the torque converter studs to line up and seat into the flex plate. I can get close enough to touch the flex plate...
Hey everyone,
I have a 2005 Ford Mustang V6 (4.0L) . Recently the check engine light came on with these three codes:
- P2195: O2 Sensor Signal Biased/Stuck Lean - Bank 1 Sensor 1 (passenger side upstream)
- P2198: O2 Sensor Signal Biased/Stuck Rich - Bank 2 Sensor 1 (driver side upstream)...
Hello, I’m currently having an issue with my 2006 Mustang GT where I’m getting a wrench light and a P061B code and an occasional P0068 code. I bought this car off my brother who had it dyno tuned(years ago) for 42lb injectors and a JLT stage 3 intake. Well a couple years ago the battery died on...
Good day everyone,
I've been fighting steering play on my 05' Mustang for a while.
Throughout the steering range, not just on center the car has about an inch of total free play in the steering.
In an attempt to correct and replace worn components the follow measures were taken
The entire...
I have a question I replaced my clutch flywheel throw out bearing and clutch cable drove it for like 200 miles then my throw out bearing broke into three pieces took it to a shop to get it fixed they replaced throw out bearing and master cylinder then charged me 600 dollars with a car that won't...
So, I bought the car cheap-ish, a few days ago. The car was running smooth as can be upon purchase from this elderly man. A day after I had taken the car home is when I stumbled upon the issues. I was taking a turn onto a different road, so I was going slow, and the car died while turning. Which...
I recently bought a SCT BDX pre-loaded performance tuner from someone. I’m new to these types of devices. I’ve read forums about different tunes from different places like Bama/AM, Brenspeed, and steeda. I’ve also read about some doing free tunes for life. I’m not sure which way to go or to go...
Hello I just recently bought a 2006 ford mustang, and it was doing good then the check engine light came on. So I used my OBD scanner and it says P0401 and code P2195 came up. So I did my research on these codes. I came to the conclusion that my EGR was bad so I replaced it. Few days go by CEL...
A few months ago we had some heavy rain where I live, and I may have driven through some large puddles and kinda drenched the throttle body. Since then, I've been facing an issue with the wrench and check engine lights coming on and the throttle response is almost non existent. After a little...
So I changed the blend door actuator on my 07 mustang. It was the one behind the dash on the upper end. I disconnected the battery(negative terminal), then passenger air bag...removed it. Then on to the actuator replacement. Reversed everything in that exact order. Started the car, and no power...
Greetings all from the UK. I have a nice 2007 Redfire GT/CS. I'm new to the S197. Where does the temperature needle sit on these cars in normal running mode. Todays temp here was 10c or around 52F. My gauge sits at 45% from cold, is this normal? Or hot?
So I pulled the trigger. Bought the cx racing kit. considering the extra parts that come with it and the slightly better build quality it was worth it to me. along with the complete/ full kit from cx racing here is the list of things I have come up with that will be needing to be ordered.
Ford...
Hey lads, so the bee bit me in the ass yesterday and since it’s a winter season and car stays either way I thought why not to do a full suspension overhaul since it’s all 06 oem stuff besides springs. Here is the list of what I decided on and all the suggestions will be much appreciated as well...