Billet Hood Pins

[Redfire_WNL]

I have a brand new set of low profile billet hood pins that were only installed never actually left these on cause my dad didnt like the look of them. I paid almost $300 for these but realize that is a outrageous price for hood pins.

I am located in Tampa, Fl and I would like to get $140 OBO for these. They are a push pin style and here is a link to the site I got them from.
http://www.dallasmustang.com/product.php?productid=17725

 

[skwerl]

You should have brought them with you Saturday. Charles (Notch) might buy them, he's all worried about the hood flopping around on his new s197.

I much prefer this style to the ones with the cables and clips on top of the hood. They look sharp.

 

[Redfire_WNL]

I completely forgot I had these, I just found them tonight in the garage while cleaning up a bit. Ill post them on there but I didnt think anybody would be interested.

 

[thundr306]

Can you measure the outside diameter of the hood flange? I want them if they will cover my current setup.

Thanks

 

[Redfire_WNL]

I found this on their website if this helps.

2.50 Inches Upper Latch Mechanism Diameter

2.20 Inches Lock Ring Diameter

1.90 Inches Latch Mechanism Height

2.88 Inches Mounting Stud Length

 

[thundr306]

I found this on their website if this helps.

2.50 Inches Upper Latch Mechanism Diameter

2.20 Inches Lock Ring Diameter

1.90 Inches Latch Mechanism Height

2.88 Inches Mounting Stud Length

Thanks..I also just looked it up on their site. It will be damn close to covering. Tomorrow I will take a look at the option of opening the holes in my hood to 1.5"

 

[Redfire_WNL]

Daily bump!

 

[thundr306]

I pulled my hoodliner down and it looks like it would be possible. Let me think about how to open up the holes without any issues....I can't use a holesaw since there are already standard hood pins holes there. Any suggestions???

 

[skwerl]

Use a unibit drill bit. You can pick up a half decent one cheap at Home Depot.

 

[Redfire_WNL]

Yup that's what I would suggest myself, just let me know man.

 

[gtcs07]

damn... i want them but i have those damn shelby ones already

 

[v8venomgt]

do they sit flush to the hood? if not how high raised above do they sit?

 

[TotoGT06]

Or get an air grinder and get sander ball bit and work your way through it till you get you needed diameter. would work like the bit shown above but the ball will smooth it out at the same time

 

[Redfire_WNL]

John from BBR has a thread with them on his and they sit flush, they also sit flush on the test fitment.

 

[INTRUDER]

PM sent

 

[RetroGT2006]

damn... i want them but i have those damn shelby ones already

Sell me your shelby ones and buy my buddy Cody's that he has for sale

 

[gtcs07]

you dont want shelby gt500 pins they have the absolute worst design ever.

 

[Redfire_WNL]

Lol Nice Rob and PM replied. Sale pending

 

[Redfire_WNL]

Payment received, sold!