update. just got done installing the modified sims. no more seat light!
how to do it.
1. order the 05-10 seat sims, they come in a set.
2. cut off the end.
3. cut out the resistor in it. (checked the resistance, 6.8 ohms, the color band on the resistors was either blue or violet, grey, gold, gold. so 6.8 or 7.8 ohms)(looked blue to me though and it measured 6.8 ohms on my DMM).
4. go to radio shack and purchase (2) 10 ohm 1/4 watt resistor packs(they have five in each pack). they are $1.19 each, so plus tax under 3 bucks.
5. solder in the resistor packs (5 resistors in parallel) equal 2 ohms. but after soldered in they measured around 2.5 ohms, close enough for the 2.2 required for the newer sensor.
6. once soldered in and covered install into plug.
walla no more light!