DIY CMDPs

[zuritausmc]

Used for a few thousand miles with hot rods, lts, and a jlt. Filled with quick steel and all the plugged holes still look good. $100 shipped obo.

 

[zuritausmc]

$80 shipped

 

[KevDon92]

How did these affect your gas mileage with the hot rods?

 

[zuritausmc]

I didn't see a change with these specifically. But it was already down because of the hot rod cams and 4.10s

Sent from my DROID3 using Tapatalk 2

 

[2008BlueGT]

are these worth the cost to buy them and have them installed? cuz i'm not sure if i would be able to do it myself...

 

[zuritausmc]

You can do it yourself. Just unbolt the intake, fuel rails from the manifold, and the bolts for the manifold, pull the manifold up (make sure there's no dirt or debris around the bottom of the manifold that can fall into the heads first) flip the maniold over and remove bolts for the plates (2 on each side I think) disconnect plug from the plate motor, insert new plates. Maybe about a 30 to 45 min job

Sent from my DROID3 using Tapatalk 2

 

[KevDon92]

Could you clean them up and snap some pictures?

 

[zuritausmc]

Sure but not until tomorrow. Im in duty right now until tomorrow morning

Sent from my DROID3 using Tapatalk 2

 

[KevDon92]

Not a problem man, take your time.

 

[Mikes06GT]

Do you need a tune with these?

 

[zuritausmc]

Could you clean them up and snap some pictures?

Do you need a tune with these?

I believe so but I dont honestly remember

 

[itsslow]

Pm sent!

 

[zuritausmc]

Sold to him ^. Thanks!

 

[itsslow]

Sold to him ^. Thanks!

Thanks!!