Forged Cobra Crank 4.6L $550

[Stephen31201]

Forged Cobra Crank 4.6L $550 -SOLD

I have a forged Ford OEM Cobra crank from a 1997 Cobra. It has already been machined and is good to go except it has a little bit of surface rust from sitting in the garage. I was going to build a forged motor over the winter, but I have decided to just run what I have and spend the money on handling and a roll cage. - SOLD

 

[Stephen31201]

AAA

 

[bunkered13]

Will this work in a 3v?

 

[Stephen31201]

I am no engine builder but I was told by ProDyno that it will fit any 4.6L up to 2009.

 

[mrt2you]

I have the almost same crank in my motor. mine is out of a 01 mach 1, now in a 08 bullitt mustang.
make 650 rwhp.

 

[drive_55_not]

Will this work in a 3v?

Yes it'll work in any 4.6 mod motor, looks like it was turned down .010 so it'll need .010 undersized main and rod bearings..

.

 

[RED09GT]

Is this plus shipping? Where are you located?

 

[Stephen31201]

I would do $500+ shipping. I am located near Burlington, NC 27215.

 

[RED09GT]

What is the weight, 60 lbs or so? I would have it shipped to 98844 (Oroville, Wa).
I'm on the fence, have to think about it for a few hours.

 

[Stephen31201]

I can ship there for $35

 

[Stephen31201]

bump

 

[Stephen31201]

sold