FRPP Intake Manifold & BMR STB

[Stang613]

Hey guys,

Does anyone know if this STB (http://www.latemodelrestoration.com/item/BMR-STB011R/Ford-Mustang-V8-BMR-Strut-Tower-Brace-Red) fits over the FRPP Intake Manifold (http://www.latemodelrestoration.com...ustang-46-3-Valve-Ford-Racing-Intake-Manifold)

Thanks guys & keep up the great work!

 

[Jarrod@latemodelresto]

I think it will, but im not 100% sure about it. Ill shoot Kelly from BMR a PM and find out.

 

[46foxcoupe]

yes, it will fit. test fitted one on mine.

oops, my bad. noticed you were referring to the 3v intake...

 

[Jarrod@latemodelresto]

Alright, i talked with Kelly, and he said he wasn't for sure, but if it did "hit" it wouldn't be by much. If its that close, then you can use a small washer to push it up just a little.

Hope this helps

 

[gtcs07]

I had an agent 47 when i had my frpp and they claim that to one of the tallest bars and it was no where near able, to fit. Only bar ive seen on factory height motor mounts clear is the bullit bar and the boss bar

 

[BMR Tech]

I know for a fact our STB011 works with the 5.0 and Boss302 intake. It clears by quite a bit.

I will do some digging, and see if I can clarify this.

Thanks!

 

[Jarrod@latemodelresto]

Thanks Kelly!