Headers are uneven!

[Sarge1400]

Measure from the ground up to the pipe to see if they're really uneven.

Unless you're just yankin' our Franklin, then kindly just bugger off.

 

[86GT351]

Didn't you already make a thread about this?

Yes he did , an evidently he is smarter than us because we are responding!

 

[07 procharger]

It's the headers. You need to bend it up or bend the other down till they are level.

Then you need to refill your OCD meds.

 

[lethe]

Darren, if you want to take your mind off of the headers try measuring all the body panel gaps.

Don't give him any new thread ideas.

 

[Torched S197]

A new eco boost 4 cylinder.

Darren, if you want to take your mind off of the headers try measuring all the body panel gaps.

Come on Bruce you should know nothing touches Darren's car besides white gloves and wax

 

[Mystickeith50]

All those in favor of pink.....Aye.

 

[Scott_0]

dude I'm really starting to think you are simply an attention whore smh

sent from my S4 using Tapatalk

 

[AnotherS197GT]

You must be bored at work.

 

[UltraKla$$ic]

Sooooooooooooo I guess I'm gonna have to split the difference of the 1/4" between the two sides to bring it back to level????

Raise the drivers side 1/8th" and that should lower the passenger side an 1/8th" = LEVEL???

 

[UltraKla$$ic]

It's the headers. You need to bend it up or bend the other down till they are level.

Then you need to refill your OCD meds.

Might try this too.

 

[rcm90]

If you bend the headers, then the primaries will not be the same..

 

[UltraKla$$ic]

If you bend the headers, then the primaries will not be the same..

 

[LS1EATINPONY]

So when you shim the motor mounts what are you going to do about the motor not being level????

 

[HEMI LOL]

 

[psfracer]

Use the BFH to correct the problem. Or the jack. I prefer the BFH.

 

[foxxxtman]

I think your speedometer isn't perfectly horizontal when your car hits 100, you should adjust your speedo so that it is or make it floating so no matter what speed you go the needle stays level hahahaha I honestly never even thought of measuring my exhaust down there, if the tips look even and such then i'm good!

 

[07 procharger]

Use the BFH to correct the problem. Or the jack. I prefer the BFH.

But then the primaries won't be the same.

 

[Boaisy]

Please move thread to ModdedMustangs...

 

[AbdullaGT500]

Use the BFH, bash in the floor, problem solved!

 

[crownaviation]

I would have that tape measure calibrated then measure again...