HELP PLZ...trouble with ABS!!!!!

romanGHR

Member
Joined
Aug 5, 2010
Posts
257
Reaction score
0
Location
mcallen tx
after i installed a spool and strange c-clip eliminaters..and also removed the evaporational system...the goes fine through 700-2500 rpms right when it hit 3000rpms i get the codeDTC p062c and the engine shuts off right away CAN SOMEONE HELP...HAS ANYONE DONE THIS
 
Last edited:

Chrome61

Member
Joined
Apr 7, 2009
Posts
677
Reaction score
6
Location
Grover,NC
I'll be first here, When you say the engine shuts off what do you mean? Does the motor quit or does the power go back to idle? If it just cuts power your abs thinks you have a lose of traction.

Try this, turn off your traction control and see what happens, If it does the same thing I don't know whats wrong unless I had the car in front of me, but if it runs right it means when you did the rear end work the sensors did not align right or you have a bad connection.
 

romanGHR

Member
Joined
Aug 5, 2010
Posts
257
Reaction score
0
Location
mcallen tx
The engine turns off it does not loose power....my traction control has been set to always be off...when they did the rearend work the sensors were not messed with they stayed in the same spot...
But I appreciate your response thanks..
 

psfracer

billy badass
Joined
Apr 6, 2007
Posts
10,917
Reaction score
82
Location
Valencia, CA
So the strange axles have the abs rings on them correct? I would expect the ABS light to come on (in the dash) and a code thrown, but never heard the car actually shutting off. We have all heard about the "wrench" or "limp mode" but not the engine actually turning off.
 

romanGHR

Member
Joined
Aug 5, 2010
Posts
257
Reaction score
0
Location
mcallen tx
Actually I was mistaken..correction--->> once I hit 2800rpms the "wrench" comes up and then the motor turns off...do you know what the solution kan be to this?
 

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top