Those of you who installed roush/RTR side splitter (removing rocker panel)

[Ssiptang]

My drill won't fit under even with the car jacked up.
So I'm trying to remove rocker panel completly then install splitters and re-install the whole thing.
Question is, I removed all the push pins(8 on the bottom, 2 on the side) and still can't take this thing off. I'm thinking there are more pins that are holding it but i just can't see it.
Any help or tip?

 

[5spd07gt]

Buy a smaller drill. I had no problem using a little skil drill that I got from Lowes for like $30. I didn't even need a jack. I just used my air ride and put it up to the max height.

 

[Morris]

There is a little metal screw at the ends. I think on the instructions ot mentions that this is what holds it up after you remove the push pins. Still, just go buy a small drill or cut down a drill bit.

 

[Pop'stang]

Rocker Panel

If I remember correctly, the rocker panel has to be worked out after removing the push pins. They are snapped in place somehow, I think they are removed in an upward motion.

 

[86GT351]

Contact BBR! They are an Authorized RTR Distributor!