v6 rear bumper made to look like a gt one at shop?

[crashdummy]

Can an exhaust shop make a v6 rear bumper look like a gt bumper ( how at the end it has a border)

http://www.mrbodykit.com/images/05-PARTS/46080_D3_2.jpg
like the one above

 

[Joser281]

Doubt it. Why not buy a take off one from someone local/online?

 

[psumustang]

probably not...not sure how that would work..

 

[JEWC_Motorsports]

OP check out www.newtakeoff.com

 

[Greg Hazlett]

I have my GT rear valence I was supposed to sell to a member on here but he is a douche bag....if you are interested in it let me know!

 

[TexasBlownV8]

The only thing you can do with the stock v6 bumper is to cut out another hole for dual exhaust. Get a GT takeoff otherwise.

 

[badgt06]

The only thing you can do with the stock v6 bumper is to cut out another hole for dual exhaust. Get a GT takeoff otherwise.

this

 

[crashdummy]

Thanks for the replies guys in this case might go with a saleen or roush and Greg how much for the rear valence

 

[Greg Hazlett]

Where are you-location?

 

[GallopingFord]

Thanks for the replies guys in this case might go with a saleen or roush and Greg how much for the rear valence

What year mustang? 05-09 or 10+?

 

[Greg Hazlett]

Good point; the one I have is for a 2010 and up.

 

[crashdummy]

oh....I have a 2007 V6 mustang... Sorry :\

 

[Greg Hazlett]

Sigh...on a side note I grew up in Flemington...small world!

 

[Ken04]

Can an exhaust shop make a v6 rear bumper look like a gt bumper ( how at the end it has a border)

http://www.mrbodykit.com/images/05-PARTS/46080_D3_2.jpg
like the one above

no, buy a GT take off rear valance. There's alot of people selling shitty looking parts that glue/tape on, but they look like ass. Either cut your drivers side out to match the passenger side, or buy a GT or GT/CS take off. The Roush piece has square outlets, you'd have to buy square muffler tips. I actually like the look of the V6 with an additional cut out. The Mrbodykit photo is for the middle piece that goes in the GT bumper.

 

[GallopingFord]

Check out eBay... you may get in luck with a great shipping deal.

 

[crashdummy]

haha Greg, this place is borin :\ but yeah nice to know

 

[silver07]

The only thing you can do with the stock v6 bumper is to cut out another hole for dual exhaust.

Agree.
I went to a body shop and they made a very nice hole for the exhaust.

 

[/\/\@TT]

You could get the trim pieces from the FRPP kit for the extra cut-out. you trim the hole, then bolt in the trim pieces, looks pretty sharp
http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=9910

 

[Ken04]

You could get the trim pieces from the FRPP kit for the extra cut-out. you trim the hole, then bolt in the trim pieces, looks pretty sharp
http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=9910

I bought that same Pypes kit, minus mufflers and exhaust cut out covers for $200. $700 from Ford seems a tad bit spendy. It's expensive to ship stock mufflers, best bet is to buy some locally for $50.