Vortech bypass valve

[555]

If you want a bov go Tial.

I like my Turbosmart Kompact for a bypass valve.
http://www.ebay.com/itm/200806923717?redirect=mobile

How much boost are you running?

 

[Redrocket06]

Around 15psi.

 

[onescruluse]

I'm running 10psi, with supporting mods, 500whp.

 

[onescruluse]

Have been running the Turboxs bypasses for a few months now. I have to say im impressed with their performance. No issues whatsoever. I knew my crappy boschs were going, had boost drop off around 7psi and wasnt pulling hard like it used to. I strapped these in and immediately picked back up the lost boost. Car was pulling like a champ again.

 

[05moneypit]

I ran the Turboxs for a year or so without any problem then went to a blow through set up.

 

[muztangman93]

The procharger big red race valve Sounds like a beast. Seems to do a hell of a job as well. Quite expensive though.

 

[JesseW.]

i'm also using the turboxs bypass and like it a lot, works and I don't have to worry about it. I took the bosch off and when pressing it, it never returned to the same spot....

 

[Bobby]

We have several guy with Paxton's, vortech, and prochargers, here is a pic of one Jeremy and my self run these on our cars with great results. Greg will also run on twin turbo set up as well.

 

[Bobby]

Also it is pretty reasonably priced along with our wastegate. Here the are side by side.
Waste gate measures 44mm
Blow off valve measures 50mm

 

[JPO8GT]

I run a vortech BV57 hell of a bov.
Run one of these and u will never run out of valve. However for a V2 / V3 its not necessary looks like Bobby is giving you some fine choices.

 

[the_shane]

Running a v3 with stock Bosch valve. Boost peaks out @ 11 lbs. No problem or fluttering. Probably will upgrade later on when increasing the boost. Will go with a Forge Motosport valve...