Recent content by cfr865

  1. C

    Rebuild advice

    What did they do lean it out way to much to pass inspection then blow it up ?
  2. C

    Will spark plugs break again?

    You could use a little PB Blaster first to be on the safe side. Has the coils ever been changed ?
  3. C

    Rebuild advice

    I also have the B326 with basically same set up as you. 650 rwhp . I currently have Ford racing 60lbs. injectors. You are the first blown b326 that I have heard of. Do you know what caused it to blow, what did Brenspeed have to say.
  4. C

    2010 Auto trans. Slips from 2nd to 3rd just bought car ... uggggg

    I have the TCI Super Street Fighter its going to need rebuilding. Where do you get the HD bands ?
  5. C

    Very Confused-PCV Valve breather or Catch Can

    I hope I understand what you are saying, I have only one pcv valve that is in the line between the cam cover and the catch can.
  6. C

    Very Confused-PCV Valve breather or Catch Can

    I have my catch can on the drivers side the pass. side is left as is. However my questions is do I need a pcv valve in the line from the cam cover to the catch can ? If so should the open side be towards the catch can or the cam cover? I have a pcv valve in line now with the open side towards...
  7. C

    Hows your cat lifespan after FI???

    How much louder was it after you did this, I have the Pypes ceramic hi flows now but after reading these post now I'm worried. I just don't want something so loud you can't hear the radio.
  8. C

    Hows your cat lifespan after FI???

    I'm thinking about going this route, how much louder are the resonators then the hi-flow cats ?
  9. C

    New problem

    I got a cel light today P0340 cam position sensor, the car runs fine, anyone else had this problem.
  10. C

    Need some advice

    Thanks for all the suggestions , the connection came off the throttle body. I didn't see it right away because of the shaker hood. Put new plugs in runs like new again.
  11. C

    Need some advice

    If it does turn out to be the hi flow cats I don't want to replace them and have it happen again. What's a good alternative without being terribly loud. I don't have to worry about emission test where I live.
  12. C

    Need some advice

    Smells like un-burt fuel. I could not smell any fuel in the engine compartment, it just had a hot smell to it. However the temp. gauge read normal , the oil pressure gauge read normal.
  13. C

    Need some advice

    This does sound the most likely to me, it seemed quite hot on the passenger side and this is where a little smoke came from. I have the Pypes hi flow cats they only have about 1500 miles on them. I'm going to have it towed to the installed tomorrow, I will have him check the cats. Hopefully...
  14. C

    Need some advice

    Yes I have Paxton 2200 ho s/c with a fully built dss 302 stroker motor. The engine turns over, it just won't start. Do you think it could be the tps or the throttle body. The oil looks fine as does the coolant.
  15. C

    Need some advice

    While driving tonight I got on it a little at about 5500 rpm the engine wnhet into fail safe mode, it acted like it was running on four cylinders. I was about a mile from home, once there I shut it off rased the hood and a little white smoke was coming from the passenger side. I could not see...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top