Clutch/Trans Issue

[2NY]

Well I just got the trans out from under the car. What a fuckin job that was. Especially with just average hand tools, some jack stands, and a jack.

But I uploaded a few pictures and curious if anyone who knows what they are looking at can tell me if anything is wrong with the clutch fingers by what they can see. When i drove the car, i never had any issues with the clutch slipping or any engagement problems. Just disengagement. So i dont want to pull the clutch if i dont have to.

Also for those who mentioned the spacer that comes with the ram clutch. I didnt pull the slave yet but it doesnt seem like there is a spacer unless i wouldnt be able to see it til the slave comes off.

 

[2NY]

anyone?

 

[gil_t2]

Did you remove the TOB?, is there a spacer?

 

[2NY]

Did you remove the TOB?, is there a spacer?

Havent done it yet. Actually completely forgot to check. Ill look at it today if its not freezing outside.

 

[2NY]

So checked the TOB finally and there was NO spacer.

 

[gil_t2]

That is most likely the problem. Get a std shim from Ram, i think it is 1/8 inch

 

[2NY]

So the install went somewhat smooth. The trans went in pretty smooth for balancing it on a jack and using some wood. I got it all buttoned up and went to connect the hydraulic line back to the slave and i lost the damn hair pin thing that holds it in place..i thought i might be able to buy one but couldnt find any so stealership here i come tomorrow.