Corbeau Harness bar

SoundGuyDave

This Space For Rent
Joined
Apr 9, 2007
Posts
1,978
Reaction score
29
Belt stretch, and angular pull. Most harness manufacturers recommend crossing the belts if you have over "X" length (IIRC 15", but look it up for safety's sake!) past your shoulders. Think of it this way: A 5* deflection with a run of 10" is basically nothing, but a 5* deflection with a 60" run (back over the harness bar then down) could be enough deflection to have the belts slip right off your shoulders... That WOULD be a Bad Thing. Not saying it WILL happen, but it could. If there's only one mount point, then it's a single-failure point, and I would think hard about it. That's effectively turning the shoulder harness into a "Y" harness, which is illegal in every race tech book that I've seen. If, on the other hand, the mount points are offset to one side behind the seat, then you have an angular pull, and that's just as bad. Best would be for them to be wide, like the stock locations for the rear belts, and cross them going over the bar. That would leave just the stretch issue, assuming your wider mounts are roughly equidistant from the front seat centerline, which they may or may not be.
 

Kris_H

Member
Joined
Jul 4, 2009
Posts
400
Reaction score
0
Location
Chino Hills, CA
Got mine today. Disassembled the factory seatbelt feed...does everyone else have two spacers per side? I superglued mine together to make it easier to feed the bolt through. Going to take a crack at installing it tomorrow. :)
 

dafridgea

Member
Joined
May 30, 2009
Posts
149
Reaction score
0
Location
NYC
After the '2005-09 Mustang Corbeau Harness Bar' is mounted are the stock seatbelts available?
 

Gray Ghost GT

Road Racing Fanatic!
Joined
Sep 29, 2009
Posts
1,269
Reaction score
14
Location
Madison, AL
I have the Corbeau Harness Bar installed in my '09. You can use your OEM seat belts with no problem. In fact, its designed to allow you to use either your stock belts or harnesses.
 

dafridgea

Member
Joined
May 30, 2009
Posts
149
Reaction score
0
Location
NYC
I have the Corbeau Harness Bar installed in my '09. You can use your OEM seat belts with no problem. In fact, its designed to allow you to use either your stock belts or harnesses.

That's great to know. Thanks vey much!
 

ArizonaGT

Road Course Member
Joined
Dec 2, 2009
Posts
1,248
Reaction score
3
Location
Phoenix, AZ
I haven't come across the restriction yet for HPDE with the 7 clubs that I run with. No problem using a harness bar without a roll bar/cage, but always best to read the rules of the club you're participating with.

Clubs might not have a problem with it, but good luck if shit actually hits the fan on/off track.
 

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top