TheFourSixThatCould
Junior Member
New here but long time stocker, I blew the bottom end of my 4.6 5spd and currently trying to remove the engine and trans as 1 as I heard this was easiest but it seems to be stuck, the trans that is. I have undone the 4 bolts to the drive shaft but was not able to disconnect the driveshaft and trans with limited jack room, and I undid the 1 bolt on the trans k member and both nuts that seem to connect to the trans, I’m wondering if I need to drop the entire k member, and if I must first physically disconnect the drive shaft front the back of the trans, I know there are 1000s of forums on this I’m sure but I can’t seem to find specific answers to these questions, and being my first engine pull at 20 I’m kinda lost, the engine wiggles around but won’t come forward. Thanks for any advice.