FS: 2011+ Boss 302 Intake

[zachcrosen]

I removed and am selling my Boss 302 intake manifold. I will include the 2' +/- of vacuum hose and 2 small hose clamps to connect to the purge valve as well as a modified intake tube coupling for an Airaid CAI.

When I originally purchased this, it was damaged in shipping and broke off the port that goes to the purge valve. So, I drilling it out and installed a hose barb fitting as can be seen in one of the photos below. This works perfectly fine and I have not had any problems with it.

I am selling because, like most people, I dont like the torque losses down low. I feel as though that is why I can not break into the 11s. Plus, I also want to powdercoat my rims and this sale will cover those costs!

I am located in NE Alabama and am looking to get $340 OBO shipped for it since it includes the coupling ($18 new from Airaid) and misc hose and clamps(<$5). I can only take Paypal.

Thanks,
Zach

 

[UltraKla$$ic]

Who's tune are you running? I'm almost certain a good tuner could tune the car to where the low end TQ loss would be gone.

GLWS. I'm trying to see if a buddy wants it.

 

[zachcrosen]

I am using the Bama tunes. I believe Dan from AM told me they probably could, but I actually forgot about it. I would rather have a little "show" right now.

Let me know if your buddy wants it!

 

[stang8psi]

are you a at or m6 car? And the sportlines aren't helping with your chase to 11's..

 

[zachcrosen]

I am a 6MT. The long story with the springs is that I had the LCAs installed, then installed the springs without adding the LCA relo brackets and wheel hop was back and bad. This week, I have finally gotten everything finished with the lowering, adjusting pinion angles, adjusting the panhard bar and tuning it all back in within spec. It may run in the 11s now, but I would rather have some matte black powdercoated rims that some power up in the stratosphere. The looks are a bit disappointing back with the stock manifold though!

 

[zachcrosen]

I love the power up top but want some looks in its place!

 

[BadHabit2Break]

What else will I need to hook this up?

 

[zachcrosen]

What else will I need to hook this up?

Unless there is any difference between the auto and manual and how the intake tube connects, this should be everything needed. Bolts are made into the manifold and the purge valve hose and clamps are included. I just had my purge valve hanging loose which worked fine for about 8k miles.

Sent from my DROIDX using Tapatalk 2

 

[BadHabit2Break]

PM Sent

 

[zachcrosen]

Still for sale. This is OBO so shoot me reasonable offers!

Sent from my DROIDX using Tapatalk 2

 

[zachcrosen]

SOLD!

Sent from my DROIDX using Tapatalk 2