looking for some shorties!

[one eyed willy]

need some shorties, looking to spend about $125-$150 shipped.

 

[nuclearmuscle523]

http://cgi.ebay.com/ebaymotors/ws/e...witem=&sspagename=STRK:MEWNX:IT#ht_3271wt_950
I offered 85 and got them
Brand new and they look very nice in person.

 

[one eyed willy]

http://cgi.ebay.com/ebaymotors/ws/e...witem=&sspagename=STRK:MEWNX:IT#ht_3271wt_950
I offered 85 and got them
Brand new and they look very nice in person.

did you install these yet? curious on fitment!

 

[nuclearmuscle523]

They fit excellent.

 

[JeremyH]

Make sure you get them cermaic coated

I have the jba tuned length shorties on my setup.

 

[07shelbyGT]

I have a set of BBK shorties. One of the oxygen sensors is stuck in the bung. Its not broke or anything its just stuck in there. They are a bit rusty but can be cleaned up easy. If you want them
$100 shipped

 

[Mustang30212]

http://cgi.ebay.com/ebaymotors/ws/e...witem=&sspagename=STRK:MEWNX:IT#ht_3271wt_950
I offered 85 and got them
Brand new and they look very nice in person.

I was just about to post a link to the same ones....they look pretty good.

RH

 

[blackgt09]

I have an off road h pipe that would go with the shorties if your interested I was asking 150plus shipping till I found out they cost that from jegs ...I'll take 125 + shiiping its brand new

Sent from my SCH-I500 using Tapatalk

 

[JeremyH]

I have an off road h pipe that would go with the shorties if your interested I was asking 150plus shipping till I found out they cost that from jegs ...I'll take 125 + shiiping its brand new

Sent from my SCH-I500 using Tapatalk

The op runs a turbo so he doesnt use a mid-pipe.

 

[one eyed willy]

I have a set of BBK shorties. One of the oxygen sensors is stuck in the bung. Its not broke or anything its just stuck in there. They are a bit rusty but can be cleaned up easy. If you want them
$100 shipped

just sent you a PM.

 

[07shelbyGT]

replied, thx

 

[Ignatowski]

Hey I bought those Ebay brand headers as well. I had them installed last Friday by a member here on the boards (Kevinatfms). He got them in under 3 hours but he did have a lift and he's done them before.

They look and work great but I am getting a slight rubbing on the steering linkage on very hard right turns. I'll probably get engine mounts to relieve that. This actually seems to be a common issue with headers.

I definitely feel a difference with these in and they quieted and deepened my exhaust note. For $135 can't be beat.

 

[one eyed willy]

my main concern is how well these will hold up on a turbo application, if they will start cracking? id like to know how thick the actual material is they are using?

 

[Ignatowski]

my main concern is how well these will hold up on a turbo application, if they will start cracking? id like to know how thick the actual material is they are using?

Ah, I'm sorry but I didn't take any measurements before. But try emailing the seller. He may have those measurements on hand.