New best on 100 shot

[anticubicle]

Not too impressive, I was expecting more but...

New track, Palm Beach International Raceway (replaced our old track, Moroso). It was my first time @ any track since last February.

This is still running no custom tune (just the JLT canned tune from the Predator with 4* timing removed and rev limiter adjusted. Nothing else). It was about 73* out.

60': 1.599
339: 5.005
1/8: 7.760
MPH: 88.46
1000: 10.146
1/4: 12.142
MPH: 112.90



Only got 2 nitrous passes in since I noticed I was leaking nitrous like crazy from the purge solenoid when I pulled into the pits after the 12.1. Couldn't fix it since I have no jack on hand on the solenoids need to be accessed from under the car

 

[stkjock]

Congrats!!

 

[Androdz]

what tires were you using?

 

[anticubicle]

what tires were you using?

ET Streets

 

[kenneth]

Congrats on the runs
Nice 60'

 

[SloSVO]

your a manual right?? what did you launch at??

so if you tweaking 4 degrees out of a 91 octane tune.. your PROBABLY still higher than stock timing right??
I'm not stating this as wrong.. just a hmm thing.. as i'm running a 87 octane tune.. with a 125 shot... which the 87 is still higher than stock timing.. were you on 91 -93 or race gas ??

 

[anticubicle]

Slo,

I'm a 5 speed, I launched at 6K spraying out of the hole. The car hooked pretty well. I was running 93 Octane. I took 4 degrees out b/c I was worried I'd melt plugs again.

Should I be taking less out? HT0 plugs, stock fuel system

 

[SloSVO]

I'm in the learning curve myself.. I know that it sucks with the helmet to hear any ping.. but i guess you didn't hear any?

I'm still on the HT1s

 

[joedls]

Slo,

I'm a 5 speed, I launched at 6K spraying out of the hole. The car hooked pretty well. I was running 93 Octane. I took 4 degrees out b/c I was worried I'd melt plugs again.

Should I be taking less out? HT0 plugs, stock fuel system

You're launching at 6K with stock clutch, tranny, and rearend?

 

[anticubicle]

You're launching at 6K with stock clutch, tranny, and rearend?

Tranny stock, rearend stock.

Clutch is a Spec 3+ and Flywheel is a Fidanza Billet Steel

 

[NotQuik]

atleast these cars have stock 31 spiline axles unlike hte 28's older mustangs came with....killer 60' man!

 

[Stangtuner]

Nice 60' and Mph. Where's the vid?!

 

[anticubicle]

Nice 60' and Mph. Where's the vid?!

Went by myself, no cameraman. I'm sure that Saturday I'll see some improvements @ the challenge. You going?

 

[anticubicle]

atleast these cars have stock 31 spiline axles unlike hte 28's older mustangs came with....killer 60' man!

Yeah im not worried about breaking an axle. I did however grind up the spider gears already, replaced those. I also busted up the differential end upper bushing. Got that replaced with the Poly Steeda bushing.

This was my first time @ the track with the Upper & Lowers.

 

[Stangtuner]

Went by myself, no cameraman. I'm sure that Saturday I'll see some improvements @ the challenge. You going?

I'm actually going on Weds for TnT. I might make the drive on Sat too if i'm feeling up for it.

 

[black05stxjt]

nice times and excellent 60'!

 

[anticubicle]

Thx guys. I'm very happy with the 60' but I feel like there should be more left in the 100 shot if I get it tuned.

 

[Stangtuner]

^ Absolutely. You should have at least 3-4 more mph with it tuned.

 

[anticubicle]

^ Absolutely. You should have at least 3-4 more mph with it tuned.

I could give two shits about MPH, I'm more focused on ET however picking up 3-4 would make me very happy.

I just dont see the need to get the tune for the 100 shot since Im upping to a 150 shot soon.

 

[Bubbamax]

Very nice times...
It's always good to see a nitrous car do well....Congrats

What brand of N20 system are you using ?