No problem. Pics on their way. The IAT relocate is plumbed into the rear most driver side intake runner. I am still in the process of removing it but as soon as I get it off I'll send you photos of the underside with the sensor. I used a 3/8" NPT tap to make the threads then sealed the sensor with Teflon tape and gray gasket maker as a safety measure. Overall the manifold is a 10 though
I've been trying to upload them yesterday and today. Can you tell me the easiest way to do it? Im having issues
pics!
intake manifold
throttle body. DOES NOT come with electronics
innovate wideband and autometer boost gauge
Saleen extreme heat exchanger
MSD coil on plugs
Strange single adjustable front struts 05-09 5k miles
You would have to install a new bung for the o2 sensor. I installed it in my rear most bung on my longtubes since they are pretty well useless anyway. Other than that yeah plug and play
You connect the SCT to the wideband using a FireWire cable SCT makes with wire end pigtails to log the analog signal from the gauge itself onto your laptop using SCT logging software. I made 527whp and 450lb ft
