What have you done to your mustang today?

GoneFord

Senior Member
Joined
Dec 30, 2009
Posts
1,151
Reaction score
1
Location
Yorktown VA
bbk shortys, MRT hi flo catted H pipe, steeda sway bar, steeda panhard bar, Dynotech drive shaft , billet aluminum fuse box cover. Looking to pick up a Moroso over flow tank and a line lock kit from JPC after I get a bit of info on the kits available. This was all done to the 2014 yesterday.

Big day. I like stock piling parts and making big changes all at once too - unfortunately sometimes that creates its own problems. Hope everything went well for you.
 

bullitt boy

Senior Member
Joined
Nov 19, 2009
Posts
1,785
Reaction score
15
Location
NJ
Big day. I like stock piling parts and making big changes all at once too - unfortunately sometimes that creates its own problems. Hope everything went well for you.

Install went like a dream. Not a squeak or bump in any of the add ons / replacement parts. Thank you Robs performance in Bellville Nj for coming in on Christmas eve and gettin er done. I do like working on my own car but when its cold out and you don't have a garage it just gets kinda old laying in the driveway when you are an old bastard like me. Car only has 970 miles on it and already my mod list is pretty much done, Bassani axle backs , mgw shifter, Airaid air box MRT rear window louvers, Silver horse racing flush louvers on order and some bling here and there.
 
Last edited:

AndrewNagle

Senior Member
Joined
Jun 20, 2008
Posts
4,272
Reaction score
1,352
Location
Mountains of NC
Installed my new BMR A-arms and A-arm support
(Had to borrow some tools from my father-in-law)

Hopefully can get an alignment tomorrow or Friday
 

blk12gt

Senior Member
Joined
Feb 20, 2013
Posts
1,054
Reaction score
0
Location
San Antonio
Dropped it off at the stealership, lets hope it doesn't sit in their lot again for two weeks... last time it sat and they didn't do anything...

Sent from my phone, spelling mistakes brought to you courtesy of tapatalk.
 

Gabe

Whippled Coyote
Joined
Aug 7, 2011
Posts
8,600
Reaction score
1,820
Location
NC
Dropped it off at the stealership, lets hope it doesn't sit in their lot again for two weeks... last time it sat and they didn't do anything....

What did you drop it off for?
 

blk12gt

Senior Member
Joined
Feb 20, 2013
Posts
1,054
Reaction score
0
Location
San Antonio
McComb's... not to hopeful, only time will tell. Last time it sat for 2 weeks, then when I called they told me the parts were on national back order and would not be in for two months. So they set me up to bring it in today but idk, I have a feeling it will be sitting for a while, and will have no problems when they get around to test driving it.

Sent from my phone, spelling mistakes brought to you courtesy of tapatalk.
 

JEWC_Motorsports

S197 Junkie
Joined
Aug 22, 2010
Posts
20,594
Reaction score
1,713
Location
Texas
I've found Northside or Bluebonnet in NB to have the best service departments. I will never go to Jordan again.

Should throw a set of aftermarket lca's in it.
 

blk12gt

Senior Member
Joined
Feb 20, 2013
Posts
1,054
Reaction score
0
Location
San Antonio
Well I had to bring it their twice just to get them to do the lca's. If I get screwed again its my fault but I figure it's not worth going through the bs just for the lca's and I cant afford to wait as my eiboch's are doing nothing sitting on my floor. At least I know that the lca's will get done, and worse case I'll have to go out to NB for the clutch/tranny issue. Is one better than the other? What happened w Jordan? Are you still under the warranty? Do you have anything done to yours?



Sent from my phone, spelling mistakes brought to you courtesy of tapatalk.
 

JEWC_Motorsports

S197 Junkie
Joined
Aug 22, 2010
Posts
20,594
Reaction score
1,713
Location
Texas
I have full suspension, longtubes, orx, and a lund tune. Car technically is under warranty but probably wouldn't get covered if I took it in. Jordan had my old car for a week and couldn't figure out why it burned so much oil. I let them do their thing and then I did mine and fixed it. I've heard good things about the other 2.
 

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top