lowering spring question

[martinr69]

I am looking at buying some FRPP K springs. Am I going to need a Adjustable Panhard Rod ? Just want to make sure I do it correct so that's why I am asking.

 

[Mustang30212]

I put the K springs on my car....see my signature. They did cause my rear axle to be off center by 1/2 inch...so I put one on. They're not expensive....you can't go wrong with it.

Is it REQUIRED....no....but worth doing IMO.

RH

 

[martinr69]

Thank I was just wanting to make sure on this. I would hate to put them on and then have to turn around and buy a Adjustable Panhard Rod

 

[Mustang30212]

I put an Edelbrock one on mine. Seems like it was $100 from Summit...matched the adjustable upper arm.

Sent you a PM also.

RH

 

[martinr69]

Yeah kinda wanting to stay around the 1 1/2..

 

[UltraKla$$ic]

I put the K springs on my car....see my signature. They did cause my rear axle to be off center by 1/2 inch...so I put one on. They're not expensive....you can't go wrong with it.

Is it REQUIRED....no....but worth doing IMO.

RH

Ditto. I used a double adj. BMR panhard. Quality piece but I'm sure Ron can hook you up nicely!

 

[Jeffs FRC]

Ditto. I used a double adj. BMR panhard. Quality piece but I'm sure Ron can hook you up nicely!

I've got a BMR on mine also. Its a nice piece.

 

[martinr69]

Ditto. I used a double adj. BMR panhard. Quality piece but I'm sure Ron can hook you up nicely!

Yeah after my Michigan trip I will be ordering the FRPP K spring from him and prob the panhand bar as well

 

[waketek516]

I used the J&M one when I dropped on H&Rs. I think it was a little pricier than some, but its a quality piece

 

[Vapour Trails]

First, there is a suspension section for questions like this.

Second, this has literally been covered a 100 times before.

If you want to do it "correct" as you mentioned, then you need it.