C&L Racer Intake

[07shelbyGT]

The intake is used bought from a member here and then used by me. The nipple for the vent tube is broken off, but you can either plug it or use a larger tube and fit it over the rest of the vent tube, this is what I did. Anyhow its in good condition.

$100 shipped

 

[Franchi]

Any pics of the part that's broken?

 

[07shelbyGT]

 

[07shelbyGT]

ttt

 

[Skarkull]

I just removed the factory nipple, and cut the C&L nipple off right from where it goes from skinny to fat, drilled it out, and installed the factory with a little silicone. Allows you to use the factory tube.

 

[07shelbyGT]

yeah I just ran large enough hose to fit over it and clamped it down and clamped it on the other side, worked just like normal.

 

[06Torch]

If you're real picky about the way it looks; you could cut off the C&L nipple from the vent tube, buy a grommet of a suitable size, place it in the C&L, and shove the factory nipple from your OEM intake in it. That would certainly look a lot better than using silicone. The guys at AutoZone don't care if you open a couple of packages from their HELP section.

Gerardo