Currie 9" for S197 2005-2009

[Born To Run]

I have for sale one Currie 9" complete with Currie 35 spline axles with 3" studs,Moser nodular iron centre section with 4:10 gears spooled,welded LCA relocation brackets.The housing was poweder coated black.I am the original owner.
This is a true bolt in mod with all the correct brackets,locations & geometry.
PRICE $1,500.00 i will meet at border,either Detroit,Sarina,or Buffalo

 

[gil_t2]

Do you still have the 9" for sale?

 

[Born To Run]

Currie

Do you still have the 9" for sale?

Yes I still have it.

 

[gil_t2]

what changes need to be made to the driveshaft?

 

[Born To Run]

Currie

what changes need to be made to the driveshaft?

It depends on what trans you have.The rear pinion is a 1350 u-joint on the rear end.Or you can change the pinion to match your driveshaft.If you have a 4R70W I have a Dynotech driveshaft that will fit.If not just call Dynotech & have a driveshaft made.
What trans do you have?

 

[gil_t2]

I have a 5R 55 and a spider shaft one piece aluminum shaft

 

[Born To Run]

Currie

I have a 5R 55 and a spider shaft one piece aluminum shaft

I would suggest ordering a new driveshaft from Dynotech.
Spydershaft made a good product,I had one(its a Ford Ranger driveshaft altered for our S197s I believe).You could sell it or keep it just in case you go back to stock someday.

 

[sportinawoody]

sig says 6060 ?

 

[irishpwr46]

i have a driveshaft that came out of a 9" rear end s197. originally belonged to 94tbird

 

[Born To Run]

Currie 9"

I have for sale one Currie 9" complete with Currie 35 spline axles with 3" studs,Moser nodular iron centre section with 4:10 gears spooled,welded LCA relocation brackets.The housing was poweder coated black.I am the original owner.
This is a true bolt in mod with all the correct brackets,locations & geometry.
PRICE $1,500.00 i will meet at border,either Detroit,Sarina,or Buffalo

TTT