Fuel Pressure Adapter Block Part #?

[A John In NJ]

Im looking for the part number from either jegs or Summit that will work with the s197... Thanks everyone!


-John

 

[tmcolegr]

Will the Zex 82035 fuel rail adapter work for you? Sorry I don't have the Jeg's or Summitt part number

 

[don_w]

I'm not sure if there is something new out there for the KBs now, but not too long ago you had to make a minor mod to make it work. I used a dremel to notch the area shown below in order to get the sending unit in there.

The following pics are courtesy of PMP...

 

[Fake_Snake]

VMP tuning i think sells adaptor blocks john

 

[BACNBLAK]

RPM outlet sells one too.

http://rpmoutlet.com/05gtfuel.htm

Yeah, Yeah, I know everyone hates RPM outlet.

 

[Rick@Metco]

http://www.metcomotorsports.com/proddetail.asp?prod=MFF0004&cat=102

 

[94tbird]

john the kb already has an adapter for fuel pressure as don showed above. you jsut need to cut away a little material on their flie adapter in the pic Don howed

 

[don_w]

RPM outlet sells one too.

http://rpmoutlet.com/05gtfuel.htm

Yeah, Yeah, I know everyone hates RPM outlet.

I originally tried on of the Motoblue adapters from RPMoutlet, and it didn't fit with the KB.

http://www.metcomotorsports.com/proddetail.asp?prod=MFF0004&cat=102

Is that designed to work with the Kenne Bell S/C?

john the kb already has an adapter for fuel pressure as don showed above. you jsut need to cut away a little material on their flie adapter in the pic Don howed

+1... works great. No need to buy anything else.

 

[Born To Run]

adaptor

john the kb already has an adapter for fuel pressure as don showed above. you jsut need to cut away a little material on their flie adapter in the pic Don howed

I just ground off some of the shoulder on the 1/8 NPT male adaptor,there is lots of meat on it.

 

[Androdz]

don sell me your adaptor

 

[don_w]

don sell me your adaptor

LOL... its been gone for a couple years already.

 

[BACNBLAK]

I originally tried on of the Motoblue adapters from RPMoutlet, and it didn't fit with the KB.




Is that designed to work with the Kenne Bell S/C?





+1... works great. No need to buy anything else.

I had this RPM Outlet adapter (blue block above rear of fuel rail) on my car with a KB 2.6H for 18 months, just took it off the other day. I'll sell it to you cheap, PM me if interested. Here's a shot of my new setup, it'll be finished this weekend.

 

[BACNBLAK]

Fuel Pressure Gauge Adapters

LOL... its been gone for a couple years already.

So I'm looking at my stock fuel rails yesterday and discovered the dummy who installed my KB originally, had STACKED my Motoblue gauge adapter and KB adapter one on top of the other on the driver's side rail! I no longer need either one, so PM me if interested. I'll even Dremel out the corner of the KB adapter if you like.