New Brembo's Installed on the 13 CS!

[kosovobandit]

thank you so much.

 

[bullitt6019]

Well done. Looks great. I was not aware that you could not order the Brembo with the CS package....

 

[Digital_Synapse]

I see that now. Never thought that there wouldn't be a clear answer on which way the slots point. Car looks good.

It doesn't matter which way the slots on the surface of the rotor point. That is cosmetic. The vanes on the rotor are the inside of the discs. Some company make the slots run with others against the vane, either way, the vanes should spin as if they were "scooping" air.

The slots don't do anything but decrease heat sink capacity and look nice. There are no raised edges that contact the rotor so there is no "bite provided by the design. Just the surface area a d friction levels of the pads and the contact area. That said... They look sexy

The calipers look darker than the factory ones, and heavier grain of the texture. I like it a lot.

 

[46Tbird]

The calipers look darker than the factory ones, and heavier grain of the texture. I like it a lot.

They look exactly the same as the stockers on my '12 GT.

Car looks great dude! When are the engine mods going to commence?

 

[BleedinBlue]

Gorgeous.

 

[shark tales]

fucking baller!

 

[cm581978]

Looks incredible

 

[04sleeper]

Well done. Looks great. I was not aware that you could not order the Brembo with the CS package....

Yeah. You can get one or the other. Not both.

They look exactly the same as the stockers on my '12 GT.

Car looks great dude! When are the engine mods going to commence?

They ARE the stock ones. I just cleaned them up a little. Hopefully should get started on the engine mods this winter.

 

[flyfaster1]

Nice, looks good.. i gotta see those rims at C&C soon though. Ill be there next month, hope to see your ride there.

 

[Kimura]

Nice, looks good.. i gotta see those rims at C&C soon though. Ill be there next month, hope to see your ride there.

He won't go to C&C anymore after they turned him away.

 

[BlackDragon]

How much did they set you back if you don't mind me asking?

I'm looking at getting a set as inexpensive as possible so i can get them custom coated...

 

[shark tales]

How much did they set you back if you don't mind me asking?

I'm looking at getting a set as inexpensive as possible so i can get them custom coated...

Post 17

 

[BlackDragon]

Sorry, should have been specific. How much were just the bare calipers?

-Ant

 

[bigwilly43729]

I am DIGGING this. Been wanting a better looking caliper for awhile.

 

[Wicked5.O]

Very nice upgrade and looks great with the rotors. So only around $900? That's not bad.

Rotors on the Brembos are free floating correct?

 

[Rolltide2012]

Can't get over how good your car looks brother!