What have you done to your mustang today?

[Seer]

Switched from Lund tune to Livernois and ordered a nitrous plate kit.

 

[Marc s]

Dynoed my car and then put stock mufflers on it and dynoed it again.

 

[white05gt]

Dynoed my car and then put stock mufflers on it and dynoed it again.

Any difference?

 

[Marc s]

It made 712whp with the Mac's and 711whp with the stock mufflers. The stock muffs were too quiet so I put the Mac's back on. I'm going to install resonators tomorrow. Trying to find a happy medium between too quiet and too loud.

 

[Ryan331]

Added a bottle of XL-3 to try and cure the rear diff moan when turning at low speeds.. Haven't driven it yet to verify

 

[NickS]

Did my first 2nd gear burnout.

 

[D98GT]

Added a bottle of XL-3 to try and cure the rear diff moan when turning at low speeds.. Haven't driven it yet to verify

Had that problem with my 2011; ended up being fixed with new bearings and spider gears

 

[Ryan331]

Had that problem with my 2011; ended up being fixed with new bearings and spider gears

Well if it comes to that, it'd be a good time to upgrade, at least..

 

[Franchi]

Drove 04 to work. Gonna detail the 06 when I get off for Woodward in a couple days.

 

[SRTthis]

wired up the 2 step last night in the LX and drove it to work today

 

[stkjock]

the LX in your sig?

 

[SRTthis]

the LX in your sig?

nah my personal LX hatch... that LX is apart right now getting refreshed for the yellowbullet race. and i dont think i could afford to drive it to work... would be like 1150 bucks in gas to make my 50 miles round trip

 

[stkjock]

ahh, ok, the YB nationals or the Georgia Radial Revolution (?)

 

[SRTthis]

ahh, ok, the YB nationals or the Georgia Radial Revolution (?)

both... we are down on compression on 2 holes right now going to fix that and REALLY lean on her... trying to go a 4.80

 

[stkjock]

good luck, I'd love to make one of those, but just not in the cards for me

 

[SRTthis]

good luck, I'd love to make one of those, but just not in the cards for me

yea its a lot of money for sure... i wish i could afford to do something like this with my car. but its also a TON of work!

 

[stkjock]

no, I meant getting to the races, not building the car

 

[SherrodMustang]

Blew out the passage side gasket on the dyno Saturday. Keeping my fingers crossed today all that is damaged is the gasket and not the heads and my motor. Made freaking awesome power, 798rwhp and 820tq at 28lbs of boost!

 

[stkjock]

damn 28psi!! what fuel?

 

[SherrodMustang]

E85 ^^