4.6

  1. Cora2010gt

    2010 4.6 overheating

    Hey all, trying to see what ideas I can get. My mustang has overheated twice in the last 6 months. I changed the water pump, radiator and thermostat, But it’s still slowly leaking coolant. Is there something specific with these 4.6s I should be looking for? Before everyone says it. No it’s not...
  2. F

    Extremely poor fuel economy and performance when engine is warm

    2007 ford mustang GT, changed the alternator and heater hoses for a friend, new gaskets on intake and coolant crossover + thermostat, as well as throttle body and injector seals. I also fixed a vacuum leak on the passenger side PCV. I also cleaned the throttle body. I'm not sure if this was an...
  3. Adomis63

    VCT Actuator Solenoids - Left vs. Right

    Hey all, I recently went to my local ford dealer to pick up a new VCT solenoid to replace the passenger side one. I had already replaced the driver's side solenoid. The parts guy pulled up on his fancy computer what part I would need and if he had it when he asks what side I needed - kinda...
  4. Andrey Sidorov

    Cam phaser replacement question

    Hey lads, planning to swap the passenger side phaser upcoming weekend , the hot idle tap is mad annoying, the question is as follows - I’m using valve cover off technique and wedge tool , not taking timing cover off like in this video Holding cam lobe with pliers , my question is, is there...
  5. Andrey Sidorov

    Slight pedal press, boost shoots up - weird boost gauge behavior

    Hey lads, I run a procharger system on my 3v with race bypass valve and fuel return system with aeromotive vacuum fpr. Since i got the car like 4 years ago i always had a weird behavior of my boost gauge- let me explain. The system has a vacuum distribution block (if it makes sense) from...
  6. Adomis63

    Intakes Systems... without a Tune

    Hey there guys Recently I had noticed a worn spot in my intake tube that may or may not be letting air in past the maf sensor. It's still been running great. Regardless, I've been interested in getting a fancy lookin CAI anyways to replace this with. I know the general consensus is to not...
  7. SixEyedSally

    2010 4.6 timing/misfiring issues

    My 2010 mustang GT is misfiring on cylinder 3 and the engine shakes when i get into 1st gear ive already dropped roughly 4k into and i dont wanna let the car go any ideas?
  8. Adomis63

    Hole in Timing Cover

    I had my timing cover and valve covers cleaned/blasted not too long ago and the guy cleaning them up noticed where one of the idler pulleys bolts in was popped through to the back side. It otherwise looks good, no cracks. Is there anything special I should do about this when I put it back...
  9. T

    Car still running 190⁰+ even with 170⁰ thermostat

    So I installed a 170⁰ thermostat and set the low and high speed fans at 186⁰ and 190⁰ as instructed a couple months back in my 2010 GT. I never actually checked with my handheld tuner the coolant numbers till now and even when cruising down the highway on a 70-75⁰ day the handheld tuner showed...
  10. T

    09-10 cmcv removal

    Within a week I'm gonna be getting my 2010 GT properly tuned at a reputable local dyno shop. I'm thinking now is the time to remove the cmcv plates that are built into the 2009 and 2010 intakes. I also know that Steeda has discontinued the plug kit they made for these intakes. My plan is just to...
  11. G

    Code P0340 after cam install help

    I just installed Ford’s hot rod cams in my 2007 GT. The car hesitated to start at first but eventually started and it now idles and runs exactly how I’ve heard in videos, the idle is stable at 800 RPM and it runs fine while driving too, no overheating or oil pressure issues, the car seems like...
  12. C

    06 GT Multiple Problems

    Okay so I’ve searched and searched but no one seems to be having the same exact problems that I am and the best way to go about this is just to explain what happened. I was sitting in a drive through and all the sudden I hear a squealing noise that sounds like some sort of siren, I look behind...
  13. Watain06GT

    Burning Rubber Smell?? 06 GT

    I have a 06 GT with 15,000 miles on it. I got it out today and drove it for about an hour. After I parked it I noticed a burning rubber smell coming from the front of the car. I don't see any leaks, and there are no lights on on the dash. I removed the cam covers several years ago to paint them...
  14. Nick93

    Newly purchased maintenance

    Hey all, this is my first post here. Just picked up an 06' GT premium 5 speed with 40,000 miles. I already replaced the oil and filter with ford oem motorcraft parts and oil. I was wondering what (if any) other preventative maintenance I should perform. While it only has 40k miles it's still a...

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top