Blower motor issue

[DravenBlade]

Hello,

New to this and new to mustangs. Just bought an 07 gt 4.6l. Previous owner declared the ac blew cold only through the defrost and would cut on and off occasionally.

So I figured blend door switch, and possibly either fuse or blower motor resistor. Well on the day I was going to pick up the parts the blower motor quit completely. So far I've installed the blend door switch, the resistor, and a blower motor itself.

I've swapped all relays with known good, and checked all fuses that I can think of in the system. I've reset the battery just to ensure the actuator was right, but I can't get anything to blow out of my vents.

P.S. the a/c clutch does engage.

 

[cavero]

Do you hear the blower motor going and the flow is just blocked? Or is it not even kicking on?

 

[DravenBlade]

It's not kicking on at all. I just tested the orange/black wire at the resistor. It reads 10.6 volts on speeds 1-3, and 0v on speed 4.

 

[86GT351]

Here is a wiring diagram for you.

 

[DravenBlade]

How can I make that image more sharp? That seems to be my biggest issue is finding the diagrams, but they're all really fuzzy.

 

[86GT351]

How can I make that image more sharp? That seems to be my biggest issue is finding the diagrams, but they're all really fuzzy.

What is your email? I'll send i to you.

 

[DravenBlade]

What is your email? I'll send i to you.

Is there a way to DM on this website?

 

[86GT351]

Is there a way to DM on this website?

Yes. Click on my screen name and then start conversation.

 

[DravenBlade]

Yes. Click on my screen name and then start conversation.

Im not seeing that option. It may be my member status. I'll just post it here, and delete after you send me the email.

[email protected]

 

[86GT351]

Emailed with a link you should be able to open

 

[Blue03Cobra]

Hello,

New to this and new to mustangs. Just bought an 07 gt 4.6l. Previous owner declared the ac blew cold only through the defrost and would cut on and off occasionally.

So I figured blend door switch, and possibly either fuse or blower motor resistor.

Firstly, welcome!

The blend door actuators themselves are also notorious for failing, so once you get the blower motor situated, you might take a look at these threads, as well:

How To: Dash Blend Door Actuator Replacement 05-09 Mustang

In total there are four: 1. Floor/dash vent actuator on driver's side behind gauge cluster (Motorcraft part no. YH 1870). 2. Defrost vent actuator on passenger side behind the center console (upper) (Motorcraft part no. YH 1870). 3. Temperature blend door actuator on passenger side behind the...

www.s197forum.com

Defrost Blend Door Actuator Replacement - 2008 GT

Just wanted to report my experience with replacing the subject matter. While moving the A/C selector switch to defrost, I heard a plastic "pop" under the dash. Later that day, I switched to A/C and panel, but the cold air came out of both the defroster vents and panel vents and cooled the...

www.s197forum.com