need help to identify compcam specs

[onehotpny]

Hi everyone,
This going sound like a crazy / stupid question, but I'd like to find out info on my Stage 4 comp cams, I purchased these back in 2007. My problem is the box that the cams came in got destroyed my mistake , this also had the cam specs in it. Is there a way to find out the specs on these cams? I'm wanting to install the FRPP cam gear locks and do an up-dated cams degree on the cams. any info very much appreciated..

 

[BruceH]

What's the part number?

 

[onehotpny]

What's the part number?

That's the problem BruceH, I can't remember, like I said it's been since '07 when these were installed. at that time they were called the stage 4 series, advertizement said very,very rough idle also installed the BeeHive springs at the time of install. we installed these the same time I installed the AHR LT's non catted version.

 

[05stroker]

Pull a valve cover and put a mirror behind the rear of the cam. The part number will be there on the end.

 

[Rasmus]

If I'm not mistaken, the old stage 4 cams became the stage 3 SPR cams.

 

[BruceH]

If I'm not mistaken, the old stage 4 cams became the stage 3 SPR cams.

That would make them 127600 or 650. The motor would be super nasty with those.

 

[Rasmus]

Then again, maybe not if the OP wants to install locks, and only remembers putting in springs.

127030 maybe?

 

[onehotpny]

Pull a valve cover and put a mirror behind the rear of the cam. The part number will be there on the end.

Thanks for the info.

 

[onehotpny]

Then again, maybe not if the OP wants to install locks, and only remembers putting in springs.

127030 maybe?

At the time of the install , the lock outs was so new that there was a lot of debate of weather to use them or not, but now after seeing other cam install threads, i'm wanting to do the lock outs. I'll be taking valve cover off to get part #. I also remember that putting the bee hive springs on was a pain in the butt to do.

 

[onehotpny]

That would make them 127600 or 650. The motor would be super nasty with those.

I do remember that at time of install , these stage 4 were the largest that comp did for the 4.6 3v other than a custom grinned. But like i said it's been so long i can't remember anything else about the cams.