Project Kama Kaase (Ka-zee)

[don_w]

Coming along great Paul! Keep posting the pics!

 

[don_w]

I think I might get the FRPP A460 block instead of the eliminator block, as the A460 block can go to 4.600 bore vs the eliminator at a max 4.500 bore.

So, what CID would you be looking at with that block?

 

[US-1]

I keep trying to get him to go 565" but he just won't budge, man.

 

[don_w]

I keep trying to get him to go 565" but he just won't budge, man.

No shit... At this point, go big or go home. hahah

 

[psfracer]

My "Billy Bad Ass" fuel system came in today......

 

[ZmanM3]

It does look pretty badass.

 

[Ken3030]

all that fuel system for a little 460 motor makeing 950? WTF

 

[ChevyKiller]

all that fuel system for a little 460 motor makeing 950? WTF

LOL, no shit - should have built it for a blower on alcohol paul!!

 

[stkjock]

he'll need it for the 300 shot he'll add!!

 

[psfracer]

 

[psfracer]

Some engine parts came in today. 4340 Eagle crank with a 4.500 stroke and the Billy Bad Ass (BBA) ESP Armor process. Eagle H-beam rods with BBA ARP L-19 rod bolts.

Block will be coming in next........

Here is some crank pictures with the BBA ESP Armor process. You can read about this process here: http://blogs.popularhotrodding.com/6457607/tech/esp-armor/index.html

 

[EagleStroker]

Looks nice Paul!

 

[don_w]

Getting there!

 

[stkjock]

that's purtyyyyyyyyyyyyyyyyyy

 

[ZmanM3]

Those look almost too pretty to hide inside an engine block.










NOT!

 

[Chris06GT]

Looks good Paul!!

 

[Matt D]

Can't wait to see the short rear end in the car

 

[psfracer]

While watching the Drag Radial Vs the World event in Georgia on the internet, I finished the fuel system today. There is some unbelievable fast cars in that event.

Will run the lines forward once the cage and motor plate is done. I ran two lines from the fuel cell to the aluminum floor, and used bulkhead fittings to run to the outside of the car. One is a -8 return for fuel, one is a -8 vent with a roll over check valve.

Here is what it looks like underneath. Still need to run the return line and the -10 line to the front.

 

[silverpoison]

it looks great Paul! awesome job!

 

[white05gt]

Looks good, nice clean install. Is the pump or lines going to be visible like the older mustangs or is it mounted high enough?